LEZYNE 1-LED-8P-V304_Noir Zecto Drive Bicycle Light Combo User Manual
- June 5, 2024
- Lezyne
Table of Contents
72826-B1
User Manual
READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating lighting vary from country to country. Inform yourself about lighting laws and regulations in the country of use. Lezyne LED lights do not conform to the German road traffic regulation StVZO.
Warnings
DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into the eyes of another.
DO NOT SUBMERGE UNDERWATER. Lezyne LED lights are water-resistant under normal
conditions but are not waterproof.
DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void the warranty. Lezyne
USA, Inc. does not accept any liability for injuries or other damages
resulting from the use of this product in any circumstances.
Warranty
In U.S. and U.K., Lezyne LED Lights carry a two (2) year warranty from the
original pur-chase date to the original owner (proof of purchase required).
Lezyne Batteries carry a six (6) month warranty from the original purchase
date. Lezyne warranties cover any manufacturing defects in materials or
workmanship. Issues not covered by warranty include normal wear & tear,
improper installation, attempting to access or modify electronics, damage or
failure due to accident, misuse, abuse, and/or neglect.
For all warranty issues worldwide, please contact the retailer that sold the
product.
For any warranty questions contact:
warranty@lezyne.com
Mounting
Operation
- ON/OFF: hold the button for two (2) sec.
- Mode cycle: click the button
ZECTO AUTO ONLY: If there is no motion detected, the light will
automatically switch to SLEEP after three (3) minutes. The light will
automatically switch back to AWAKE as soon as it senses motion or the button
is clicked.
MODE MEMORY : The light remains in the output setting it is switched OFF.
THERMAL PROTECTION: If the operating temperature of the light is too
high, the light automatically lowers the lumen output.
Run Times and Modes
ZECTO FRONT:
ZECTO REAR/AUTO:
ZECTO MAX REAR:
Battery Indicator
LEDs located on the sides display the current battery status for a few seconds when the light is first turned on when pressing the button to toggle between modes and if the ON/OFF button is quickly pushed when the light is off. When the light is on only the orange LED stays continuously lit.
Charging
Before using your Lezyne LED Light for the first time, fully charge the battery. To charge your light:
-
Open the USB protective cover on the bottom of the light
-
Connect micro USB cable and light to the powered USB port
-
Once charging, the side LED will flash green
If the battery indicator does not flash when plugged in, a selected USB port may not be powered – try another USB port. Light will be charged after 4-6 hours or when the side LED illuminates solid green. -
Remove the light from the charger and reinstall the USB protective cover—ensure the USB protective cover Is fully installed for water resistance
More Information
For more Information on Lezyne products, visit:
htto://lezyne.com
Lezyne USA, 645 Tank Farm Rd., Unit F, San Luis Obispo, California 93. 72826-Y12-LED-SECTOR-FRONT-REAR-AUTO-MAX-GUIDE-ROB1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>