rugged radios VSC-RC01 Variable Speed Remote Controller Instruction Manual
- June 13, 2024
- rugged radios
Table of Contents
REMOTE CONTROL OF VARIABLE SPEED CONTROLLER
Instruction Manual
Product Model: VSC-RC01
Product Application:
This product adopts 2.4G wireless signal with strong penetrating ability and wide coverage, which is used to control the controller box to regulate the flow of water pump.
Technical Parameter:
1 Remote distance ≥30M 2 Power Supply: 2 X 1.5 V AAA Battery
Product Certificate: FCC, FCC ID: 2A9I8-221212
Function Instruction:
Step 1: Press 1 Power button to turn on variable speed controller.
Step 2: Press 2 Mode button to choose modes , manual mode, timer mode and
cycle mode available.
Step 3: Long press 3 Timer button for 2 seconds to set corresponding water
flow of on/off time If you want regulate the water flow or adjust the time,
please press 4 UP/ 5 Down button.
Step 4: Long Press 6 Clock button for 2 seconds to set local time
Battery Installation:
Step 1 : Slide off the battery cover via the arrow direction
Step 2 : Install battery
Step3 : Put the cover back
Product Dimension:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.
FCC Caution:
Changes or modifications not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment.
FCC Statement:
“This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>