GE UNCAC-DW-WTLAF Under Cabinet Power Box 20A Outlet Installation Guide
- June 13, 2024
- GE
Table of Contents
GE UNCAC-DW-WTLAF Under Cabinet Power Box 20A Outlet
PRODUCT SPECIFICATION
Note: when USB-A and USB-C work simultaneously, both port’s output is 5V.
- Outlet
- installation hole cover
- Pre-installed mounting screw
- USB-A
- USB-C
- Input /Output Port
- Receptacle cap
- Overload protection reset button
BEFORE YOU BEGIN
- Read these instructions completely and carefully.
WARNING
- DO NOT USE WITH DIMMERS
- MAXIMUM 1 OUTLET PER CIRCUIT
- OUTLET MAXIMUM 120V AC 500W
- ONLY INSTALL ON A GFCI-PROTECTED CIRCUIT
Before using the USB charging function, please confirm that the input voltage and current of the charging device are compatible with this product.
PREPARE ELECTRICAL WIRING
- Electrical Requirements The LED fixture must be supplied with 120VAC 60Hz.
- Grounding Instructions The grounding and bonding of the overall system shall be done in accordance with National Electric Code (NEC) Article 600 and local codes.
PACKAGE CONTENTS
OTHER AVAILABLE ACCESSORIES
-
UNCAC-PI-WTLO
60″ Grounded Power Cord Enables the fixture to be plugged directly into an outlet -
UNCAC-PI-WTLF
36″ Linking Cable Link 2 fixtures together up to 36″ apart -
UNCAC-PI-WTLE
24″ Linking Cable Link 2 fixtures together up to 24″ apart
COMPATIBLE FIXTURES
TOOLS REQUIRED
Note: This device complies with port 15 of the FCC Rules. Operation is subject to the following two conditions;(1) This device may not cause harmful interference; (2) this device must accept any interference received, including interference that may cause undesired operation.
INSTALLATION
- Turn off the power source to the power supply where you are installing the product in. Ensure that the accessory is installed in a GFCI-protected circuit.
- Place the product in the desired position. Mount it by securing and tightening the pre-installed mounting screws. Mounting screws are suitable for cabinet bottoms 3/8″ or thicker.
- Remove the plastic receptacle cap that covers the INPUT and OUTPUT ports. Keep the caps carefully in case for further usage.
- Option 1: Connect this product with lighting fixtures with a Linking Cord.
- Option 2: Connect this product with lighting fixtures with a short connector.
- Option 3: Connect this product to a grounded three-prong electrical outlet with a Power Cord.
- Insert the installation hole covers. Turn on the electricity.
- When the load exceeds the maximum allowable load, the overload protection switch will cut off the circuit. Please remove the load and press the button of the overload protection switch to reset.
GE Lighting, a Savant Company
GE is a trademark of General Electric Company. Used under trademark license. INFORMATION PROVIDED IS SUBJECT TO CHANGE WITHOUT NOTICE. ALL VALUES ARE DESIGN OR TYPICAL VALUES WHEN MEASURED UNDER LABORATORY CONDITIONS. @2021 GE Lighting, a Savant Company.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>