VEVOR 1.6 Rise Cuttable Threshold Ramp for Sweeping Robot User Manual
- June 13, 2024
- VEVOR
Table of Contents
CURB RAMP
USER MANUAL
Technical Support and E-Warranty
Certificate www.vevor.com/support
1.6 Rise Cuttable Threshold Ramp for Sweeping Robot
We continue to be committed to provide you tools with competitive price.
“Save Half”, “Half Price” or any other similar expressions used by us only
represents an estimate of savings you might benefit from buying certain tools
with us compared to the major top brands and doses not necessarily mean to
cover all categories of tools offered by us. You are kindly reminded to verify
carefully when you are placing an order with us if you are actually saving
half in comparison with the top major brands.
NEED HELP? CONTACT US!
Have product questions? Need technical support? Please feel free to
contact us:
[email protected]
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.
INSTRUCTIONS
- For your information, please read these installation instructions before using your curb ramp; Please keep all instructions and refer to them when necessary. It is normal the product has a slight smell. we recommended ventilating before use to avoid the smell.
WARNINGS
Incorrect installation can cause debris to collect, impeding water flow.
Used in curbs, steps, and uneven pavement.
- Read and understand manual.And SAVE THESE INSTRUCTIONS.
- Inspect before every use; do not use if parts loose or damaged.
- Clean dirt, oil and debris off ramps and allow ramps to dry.
- Set up only on solid, level, dry surface.
- Be aware of dynamic loading! Sudden load movement may briefly create excess load, causing product failure.
- Use as intended only.
- Clean ramps. Prior to each use, clean dirt, oil, or any debris off ramps.
- This product is not a toy. Do not allow children to play with or near this item.
- All persons not involved in the loading process must stand clear of the loading ramps. Keep children away. Children must not be allowed in the work area.
- Store idle equipment. When not in use, store ramps in a dry location to inhibit rust.
- The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
PARAMETER
Curb ramp – Parameter
TYPE| Picture| ITEM| Model| Ramp Height| Product size/mm| Packaging
Size/mm| G.W. kg| Ramp Quantity| Load
Limit| Water Proof groove
A| | SKU1| KR-17| 2.6inch| 1220x410x65| 1230x420x90| 22.| 1pcs| 15 tons| Y
SKU2| KR-17| 2.6inch| 1220x410x65| 1240×424 x 155| 43| 2pcs| 15 tons| Y
SKU3| KR-17| 2.6inch| 1220x410x65| 1240x425x210| 64| 3pcs| 15 tons| Y
B| | SKU4| KR-03| 3.7inch| 1000x250x90| 1010x260x100| 15.| 1pcs| 15 tons| Y
SKU5| KR-04| 4.25inch| 500x300x105| 510x310x120| 9| 1pcs| 15 tons| Y
SKU6| KR-05| 6inch| 491x370x152| 510x390x185| 14.| 1pcs| 15 tons| Y
SKU7| KR-06| 4.3inch| 500x320x110| 510x330x150| 20.| 2pcs| 15 tons| Y
SKU8| KR-07| 5inch| 482.6x330x 127| 500x340x180| 20.| 2pcs| 15 tons| Y
SKU9| KR-05| 6inch| 491x370x152| 510x390x250| 28.| 2pcs| 15 tons| Y
C| | SKU10| KR-09| finch| 1130×241.3×25. 4| 1140x250x50| 6| 1pcs| 15 tons| Y
SKU11| KR-10| 1.5inch| 1100x320x38| 1110x330x50| 11.| 1pcs| 15 tons| Y
SKU12| KR-11| 2inch| 1110×406.4×50| 1120x417x60| 13| 1pcs| 15 tons| Y
SKU13| KR-12| 3inch| 901.7×457.2×76. 2| 912x468x87| 16.| 1pcs| 15 tons| Y
SKU14| KR-13| 3.5inch| 901.7×533.4×88•
9| 912x544x100| 22.| 1pcs| 15ons
t| Y
SKU15| KR-14| 4inch| 0. .
1 8×10 7×619
9 .6 1| 910x640x136| 26.| 1pcs| 15
t ons| Y
D| | SKU16| KR-15| 1.2inch| 900x200x30| 920x220x60| 5.| 1pcs| 15 tons| N
SKU17| KR-16| 1.6inch| 900×20040| 923x232x64| 6.| 1pcs| 15 tons| N
INSTALLATION STEPS FOR TYPE A(SKU1~SKU3)
STEP 01 select the dimensio n
The sizes of the type A curb ramps are listed in parameter table. The load
limit is 15 tons. Please choose the size that matches the ramp . STEP 02
Align ramp sections
Facing your house, ensure that the ramp sections are in the correct
order,paying attention to the angle of the ends. STEP 03 Flip ramp into
street
Turn the ramp sections over into the street so that they are flat side down.
If you have additional center sections, the hardware from one side of that
ramp must be removed. To remove excess hardware from one side, strike
underneath the bolt head with the claw portion of your hammer and extract.
STEP 04 Tighten the screws
M8*10 Expansion Bolts need to be fixed for installation. The groove can be
used for drain water or protect cables. the blind holes in the ramp need to be
drilled through to allow the screw to pass through the ramp and lock into the
ground
INSTALLATION STEPS FOR TYPE B(SKU4~SKU9)
STEP 01 Select the dimension
The sizes of the type B curb ramps are listed in parameter table. The load
limit is 15 tons. Please choose the size that matches the ramp . STEP 02
Align ramp sections
Facing your house, ensure that the ramp sections are in the correct
order,paying attention to the angle of the ends.
STEP 03 Sighten the screws
M8*10 Expansion Bolts need to be fixed for installation.the blind holes in the
ramp need to be drilled through to allow the screw to pass through the ramp
and lock into the ground.
INSTALLATION STEPS FOR TYPE C(SKU10~SKU15)
STEP 01 Select the dimension
The sizes of the type C curb ramps are listed in parameter table. The load
limit is 15 tons. Please choose the size that matches the ramp. STEP 02
Tighten the screws
M8*10 Expansion Bolts need to be fixed for installation.the blind holes in the
ramp need to be drilled through to allow the screw to pass through the ramp
and lock into the ground.
INSTALLATION STEPS FOR
TYPE D(SKU16~SKU17)
STEP 01 Dimension select
The sizes of the type D curb ramps are listed in parameter table. The load
limit is 15 tons. Please choose the size that matches the ramp. STEP 02 Use
the adhesive tape
Use double-sided tape to secure to the ground.
How to Keep Ramp From Moving Out of Place
Don’t enter the driveway at an angle. If you can drive out to the street with
both tires impacting the ramps at the same time, the ramps will stay put.
How to Adjust Position of A Curb Ramp Set
Straddle the ramp at the center.Pick up the ramp and lean back in the
direction you want it to go.
How to Clean Beneath The Ramp
Clean out underneath the ramp 2 ~3 times a year or more frequently if you have
a lot of gutter build-up. To turn the ramp over, start at one end, pull the
top of the ramp up and out toward the street. Use a hose to clean the ramp’s
underside and the gutter. To return in place, simply start at one end and flip
back toward curb as you walk along the ramp.
How to Take A Curb Ramp Apart
Turn ramp over into the street, so the flat side is down. Put a flat head
screwdriver between the waterway rubber and bolt. Pry up toward the waterway
lifting the bolt up enough to remove the nuts. Using a hammer and screwdriver
as a punch, drive the bolt back through the adjoining section. Be careful not
to damage the bolt threads.
How to Add Another Ramp Section (only for type A)
After removing the nut, using a screwdriver as a punch, hammer the bolt back
through the adjoining section. Be careful not to damage the bolt threads.
Importer: WAITCHX
Address: 250 bis boulevard Saint-Germain 75007 Paris
Importer: FREE MOOD LTD
Address: 2 Holywell Lane, London, England, EC2A 3ET
Manufacturer: Zhejiang Luba Traffic Technology Co.,Ltd
Address: No.300 West Guangming Road, Sanmen, Zhejiang, China
Made In China
EUREP UK LTD
UNIT 2264, 100 OCK STREET, ABINGDON
OXFORDSHIRE ENGLAND OX14 5DH
EUREP GmbH
Unterlettenweg 1a, 85051
Ingolstadt, Germany
Technical Support and E-Warranty Certificate
www.vevor.com/support
Documents / Resources
|
VEVOR 1.6 Rise Cuttable Threshold Ramp for Sweeping
Robot
[pdf] User Manual
1.6 Rise Cuttable Threshold Ramp for Sweeping Robot, 1.6 Rise, Cuttable
Threshold Ramp for Sweeping Robot, Threshold Ramp for Sweeping Robot, Ramp for
Sweeping Robot, Sweeping Robot, Robot
---|---