GE Battery Powered Light Bar with Motion Sensor LED Cool White User Guide
- June 13, 2024
- GE
Table of Contents
GE Battery Powered Light Bar with Motion Sensor LED Cool White
USAGE
Open the back cover and pull the plastic card out from the battery
compartment, then close the back cover.
Use the slider to select the desired state.
- ON: Always on
- OFF: Always off
- AUTO: Use motion to automatically turn the light on. The light will switch off 30 seconds after the last motion is detected.
INSTALLATION
THERE ARE 2 MOUNTING METHODS
Adhesive Tape
- Attach the double-sided tape to the back cover of the light bar, then stick the bar to a dry and clean location.
Screws
- Install two screws to the mounting surface with a 4.3-inch gap, as shown above. Hang the light bar to the screws.
GE is a trademark of General Electric Company. Used under trademark license.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>