Ariete 2791 Jet Force Bagless Cyclone Vacuum Cleaner Instruction Manual
- June 13, 2024
- Ariete
Table of Contents
Ariete 2791 Jet Force Bagless Cyclone Vacuum Cleaner
IMPORTANT SAFEGUARDS
READ THESE INSTRUCTIONS BEFORE USING THE APPLIANCE:
When using the appliance, it is necessary to follow some basic precautions:
- Always make sure that the voltage of the mains electricity supply is the same as that indicated on the rating plate of the appliance and that the system is compatible with the appliance power.
- This appliance conforms to the 2006/95/EC and EMC2004/108/EEC directives.
- The appliance may only be used for its intended purpose, which is for vacuuming dust from surfaces within the home. Any other use is to be considered improper and therefore, dangerous. The manufacturer may not be held liable for any damages caused by improper, incorrect or unreasonable use.
- Do not use to vacuum hot ash, large pieces of glass, rubble, sharp or pointed items, or liquids.
- To prevent dangerous overheating, always unwind the power cord fully and unplug the appliance from the mains when the appliance is not in use.
- Only plug the appliance into an AC socket.
- Never use the appliance without a bag or motor filter or if the bag or filter is broken or damaged.
- Never use the appliance on wet surfaces.
- Never suck up liquids.
- NEVER PLACE THE APPLIANCE IN WATER OR OTHER LIQUIDS.
- Do not touch the appliance when hands or feet are wet or moist.
- Never use the appliance with bare feet.
- Do not leave the appliance exposed to the elements (rain, sun, etc.).
- Do not store the appliance in proximity to sources of heat (e.g. radiators).
- Always unplug the appliance before cleaning it or changing the filters.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Never unplug the appliance by pulling on the power cord.
- Make sure that the power cord does not come into contact with sharp or hot surfaces.
- Never use the appliance if the power cord is damaged.
- If the cord is damaged, it must be replaced by the Manufacturer, by an Authorised Technical Assistance Centre or in any case, by a similarly qualified person, in order to prevent any risks.
- Always switch on the appliance with the power regulator set to a minimum.
- Unplug the appliance from the mains electricity after each use.
- In the event that you decide to dispose of the appliance, we advise you to make it inoperative by cutting off the power cord. We also recommend that any parts that could be dangerous be rendered harmless, especially for children, who may play with the appliance or its parts.
- Packaging must never be left within the reach of children since it is potentially dangerous.
DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE
- Foot-operated cord rewinder button
- Suction power regulation dial
- Foot-operated on/off switch
- Dust container lock/release button
- Dust container handle
- Suction device coupling
- Dust container
- Appliance body
- Outlet air filter housing
- Top carry handle
- Floor brush
- Telescopic tube
- Slider device
- Suction device
- Attachment storage compartment
- Small suction device with brush
- Narrow suction nozzle
- Handle
- Manual air inlet valve
- Release buttons
ATTACHMENTS
Floor brush (11)
Ideal for cleaning any type of surface. Use the device on the top of the
attachment to:
- retract the bristles when cleaning carpets or rugs;
- lower the bristles for smooth floors such as PVC, parquet or tiles.
Small suction device with brush (16)
This can be used to remove dust from books or other delicate items, such as
picture frames, etc. It is suitable for cleaning upholstered furniture,
mattresses, cushions, curtains, etc… This attachment can also be fitted
directly to the handle (18).
Narrow suction nozzle (17)
This suction device is ideal for cleaning between the folds on fabrics,
joints, corners or niches that are impossible to reach using the floor
cleaning device. This attachment can also be fitted directly to the handle
(18).
VACUUM CLEANER ASSEMBLY
WARNING: Before fitting or removing the attachments, always make sure that the vacuum cleaner has been unplugged from the power mains.
- Fit the suction device (14) into the air inlet opening (6) and press it in until it clicks into place. To remove it, it is necessary to press the two release buttons (20) at the same time and to pull it out (Fig. 2).
- Insert the telescopic tube (12) into the handle (Fig. 3).
- Push the slider device (13) forward and pull the bottom section of the tube out to the required length (Fig. 4). Then simply release the slider and the device will return to its original position.
- Fit the required attachment to the telescopic tube.
USING THE APPLIANCE
- Caution: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid any possible damage to the cleaner itself.
- First of all, before using this appliance, unwind the power cord completely and plug the appliance into the mains socket.
- To switch on the appliance, press the foot switch (3) on the vacuum cleaner. While using the appliance, pull it along behind you as if it were a trolley.
- Important: In some cases, the appliance may “whistle” when switched on. This is not a fault and the noise will go away with time.
Suction power adjustment
It is possible to regulate the suction power as required, using the relevant
dial (2). We recommend using a minimum power for delicate materials. Select
medium suction power for mattresses, upholstered furniture and carpets. Select
maximum suction power for tile, wood or other resistant floors.
Secondary air valve (19)
The secondary air valve (19) is on the hand grip (18) and it is used to
regulate suction power. The wider the valve is opened, the less the suction
power and vice versa.
- To open the valve, push it upwards and to close it, push downwards.
- Open the valve to prevent curtains and the like from being sucked into the cleaner.
- Minimum suction power for curtains and delicate materials.
- Medium suction power for cushions, mattresses and carpets.
- Maximum suction power for tiled, wood or other resistant floor surfaces that are heavily soiled.
- WARNING: Switch off the vacuum cleaner immediately if the air inlets, brushes or telescopic tube become blocked. Remove the cause of the blockage before switching the vacuum cleaner on again.
After using the vacuum cleaner
Switch off the appliance after use by pressing the foot-operated switch (3),
with your hand or foot. After this, unplug the appliance and wind the cord
back inside its housing by holding down the foot operated rewinder button (1).
The cord will rewind itself immediately inside its housing.
WARNING: While rewinding the power cord, guide it in the right direction
by hand to prevent any risk of injury to yourself.
Put the appliance away, fitting the attachment storage compartment (15) on the
handle (18) and hooking on the narrow suction nozzle (17) and small suction
device with brush (16) (Fig. 5).
Carrying the vacuum cleaner
This vacuum cleaner has a handle on the top (10) for carrying purposes.
CLEANING AND MAINTENANCE
WARNING: Before carrying out any cleaning or maintenance operation,
switch off the appliance and unplug it from the mains power.
The dirt vacuumed up will enter the dust container (7). The air is then
cleaned through a permanent washable filter inside the dust container, by a
filter to protect the motor and by an air outlet filter, located on the
underside of the appliance.
WARNING: Never use the vacuum cleaner if any filter is missing or
damaged. Any dust cleaned up will enter the appliance and damage the motor.
WARNING: Clean the filters regularly or in any case, whenever the suction
power seems to be reduced.
Emptying the dust container (7)
The transparent surface of the dust container makes it easy to see when this
needs to be emptied.
- Press the release button (4) and at the same time, remove the dust container (7) using the relevant handle (5) (Fig. 6).
- Use the two levers at the back to open the relevant hatch (Fig. 7).
- To clean the inside of the container (7), it is possible to remove the washable filter by turning it anticlockwise and pulling it outwards (Fig. 8).
- Empty the dust container (7) (Fig. 9).
- To refit the filter on the dust container (7), insert it and turn it clockwise. Click the hatch shut.
- Refit the dust container (7) onto the body of the appliance (8) so that it clicks into place.
- IMPORTANT: When the dust container becomes full, it is advisable to place a plastic bag over the top and empty it inside the bag itself to prevent dust and dirt from leaking out.
Cleaning the motor filter
The motor filter and its special covering need to be cleaned on a regular
basis.
- Use the two levers and lower the hatch in the back section of the appliance (Fig. 10).
- Remove the filter and clean it under running water (Fig. 11). Leave it to dry thoroughly.
- Refit the filter and click the hatch shut.
- WARNING: Only wash the filter in clean water, without using soap or detergents.
- WARNING: This operation is necessary at least once every 6 months or in any case, when the suction power is notably reduced.
Cleaning the air outlet filter
This filter cleans the air one last time before it leaves the vacuum cleaner.
To clean the filter, proceed as follows:
- Upturn the appliance and open the air outlet filter grid (9).
- The air outlet filter can be seen once the grid has been opened.
- Clean the filter in cold water and leave it to dry.
- Refit the clean (or new) air outlet filter into the grid and return this to the appliance, pressing it down until it clicks into place.
WARNING: Only wash the filter in clean water, without using soap or detergents.
Cleaning the vacuum cleaner
The casing, dust container and filter seats can be wiped with a damp cloth if
necessary. No liquid must enter the vacuum cleaner in the process. Never use
heavy-duty cleaning substances (stain removers, thinners) because they can
corrode the plastic surfaces. Only put the plug back into the mains socket
when you are sure that all parts are thoroughly dry.
Important: Do not lubricate or oil any rotating parts, since this could
cause dirt and fluff to stick even further
Cleaning the brushes
While the appliance is switched on, move your hand between the bristles on the
brush to free them of any trapped dust, which will then be sucked into the
cleaner.
FAQ’s
What are the important safety precautions when using this vacuum cleaner?
Always check the voltage compatibility with the appliance. Use it only for its intended purpose, i.e., dust vacuuming within the home. Avoid vacuuming hot ash, large glass pieces, sharp items, or liquids. Unplug the appliance when not in use to prevent overheating. Use only with a bag or motor filter, and never on wet surfaces or to suck up liquids.
Can I submerge the appliance in water or other liquids?
No, never place the appliance in water or any liquids.
What should I do if my hands or feet are wet or moist while using the vacuum cleaner?
Avoid touching the appliance to prevent electrical hazards.
Is it safe to use the vacuum cleaner with bare feet?
No, always wear appropriate footwear when using the appliance.
Can I leave the vacuum cleaner exposed to outdoor elements like rain or sun?
No, it should not be exposed to outdoor elements.
What's the recommended procedure for cleaning and changing filters?
Always unplug the appliance before cleaning or changing filters. Replace damaged filters promptly.
Is this vacuum cleaner suitable for use by children or individuals with reduced capabilities?
This appliance is not intended for use by children or those with reduced physical, sensory, or mental capabilities without supervision or instruction.
What precautions should I take when storing the appliance?
Avoid storing it near heat sources like radiators.
How should I handle the power cord during use and storage?
Fully unwind the cord during use and wind it back using the cord rewinder button after each use.
What are the attachments included with the vacuum cleaner, and how should I use them?
Attachments include a floor brush, small suction device with a brush, and a narrow suction nozzle. Use the floor brush for various surfaces and adjust the bristle height accordingly. The small suction device is suitable for delicate items and upholstered furniture. The narrow suction nozzle is ideal for hard- to-reach places.
How do I use the vacuum cleaner effectively?
Before use, unwind the power cord completely and plug it into a main socket. Use the foot switch to turn on the appliance. Adjust suction power using the dial as needed. Move the vacuum cleaner as if it were a trolley. Note: Some noise upon startup is normal and will subside.
How can I maintain optimal suction power and prevent blockages?
Open the secondary air valve to adjust suction power for different surfaces. If blockages occur in air inlets, brushes, or telescopic tubes, switch off the vacuum cleaner, remove the blockage, and then restart it.
Download This PDF Link:Ariete 2791 Jet Force Bagless Cyclone Vacuum Cleaner Instruction Manual
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>