Holmes 32510138 16 Inch Big Breeze Table Fan Instruction Manual
- June 13, 2024
- Holmes
Table of Contents
Holmes 32510138 16 Inch Big Breeze Table Fan
PLEASE READ AND SAVE THESE
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precau- tions should always be taken including the following:
- Read all instructions carefully before using this appliance.
- Use fan only for purposes described in the instruction manual.
- This fan is not intended for continuous operation or equivalent.
- To protect against electrical shock do not immerse unit, plug or cord in water or spray with liquids and plug the appliance directly into a 120V AC electrical outlet.
- Close supervision is necessary when any appliance is used near children.
- Not intended for use by children.
- Unplug from outlet when not in use, when moving fan from one location to another, before putting on or taking off parts and before cleaning.
- Avoid contact with moving parts.
- Do not operate in the presence of explosive and/or flammable fumes.
- To avoid fire hazard, never place the cord under rugs or any parts near an open flame, cooking or other heating appliance.
- Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, or has been dropped/damaged in any manner. Discard fan or contact customer service.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runner, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- The use of attachments not recommended or sold by the appliance manufacturer may cause hazards.
- Do not let the cord hang over the edge of a table, counter or come in contact with hot surfaces or leave exposed to high traffic areas.
- Do not use outdoors.
- To disconnect, grip plug and pull from wall outlet. Never yank on cord.
- Always use on a dry, level surface.
- Do not operate fan until fully assembled with all parts properly in place.
- This product is intended for household use only and not for commercial or industrial applications.
- WARNING: To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
- WARNING: To Reduce The Risk Of Fire, Electric Shock Or Injury To Persons, Do Not Use Replacement Parts That Have Not Been Recommended By The Manufac- turer (e.g. Parts Made At Home Using A 3D Printer).
- For models with overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded or contact customer service.
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet.
DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY.
PARTS AND ASSEMBLY
ASSEMBLY INSTRUCTIONS (SEE FIGURE 1)
NOTE: MAKE SURE YOU REMOVE ALL CONTENTS OF THE PACKAGE. PLEASE CHECK PACKAGING MATERIALS FOR PARTS THAT COULD BE REQUIRED TO OPERATE THIS FAN.
Estimated assembly time: 5–10 minutes
- To assemble the base, insert the Fan Neck (J) into the Fan Base (L) and snap in place to secure
- Line up the 2 holes of the Rear Grill (F) with the posts on the Motor Housing (H) assembly.
- Secure Rear Grill (F) to Motor Housing (H) with Rear Grill Mounting Nut ( E) . Turn clockwise to tighten.
- Secure Fan Blade (D) to Motor Shaft with the Blade Cap ( C ). Align blade notches and push into the shaft cross pin. Turn counter clockwise to tighten.
- Line up the clips around the front and rear grill, securely fasten the front grill to the rear grill by snapping together.
Figure 1
- A. Logo Plate
- B. Front Grill
- C. Blade Cap
- D. Blade
- E. Rear Grill Mounting Nut
- F. Rear Grill
- G. Motor Shaft
- H. Motor Housing
- I. Oscillation Knob
- J. Fan Neck
- K. Speed Control Knob
- L. Fan Base
FEATURES – OPERATIONS
OPERATING INSTRUCTIONS
-
Set fan base on a dry, level, stable surface.
-
Plug cord into any standard 120 volt AC outlet.
-
The speed is adjusted by moving the Speed Control
Knob (K) to the desired setting:
O
1-Low
2-Medium
3-High -
To start oscillation, press the Oscillation Knob (I) down.
To stop oscillation, pull Oscillation Knob (I) up.
TILT ADJUSTMENT
Gently move the fan head up or down manually to the desired angle. An audible click will confirm each angle adjustment.
USER SERVICING INSTRUCTIONS
Follow these instructions to safely and correctly care for this fan.
REPLACEABLE FUSE
If the (2.5 Amp, 125 Volt) replaceable fuse blows, please visit our website at www.getholmesfans.com for information on how to order a new fuse. Follow the below instructions to replace the fuse on the plug.
-
Unplug the fan.
Grasp plug and remove from the receptacle or other outlet device.
NOTE: Do not unplug by pulling on cord. -
Open fuse cover, located on the top of the plug, by using your thumb or a flathead screwdriver to slide the cover towards the prongs.
NOTE: Ensure the fuse cover is completely open before attempting to remove fuse. -
Remove fuse carefully by using a small screwdriver to pry it from the compartment at the metal ends of the fuse. (See Figure 2)
-
Place plug on a solid, flat surface. Insert new 2.5
Amp, 125 Volt fuse into fuse compartment. Use a small screwdriver to secure the metal ends of the fuse into the compartment.
CAUTION: Risk of fire. Replace fuse only with 2.5
Amp, 125 Volt fuse. -
Slide fuse cover closed completely.
NOTE: If fuse cover is difficult to close, make sure the fuse is completely secured in place by pressing on metal ends of the fuse.
CAUTION: Risk of fire. Do not replace the attachment plug. It contains a safety device (fuse) that should not be removed. Discard product if the attachment plug is damaged.
CLEANING / MAINTENANCE
FAN CLEANING
- Always unplug the fan before cleaning.
- Do not allow water to drop on or into the fan housing.
- Use only a soft cloth moistened with a mild soap solution.
- Do not use harsh chemicals such as gasoline, thinner or benzene as a cleaner.
- Do not attempt to remove the fan blade.
FAN BLADE CLEANING
- Always unplug the fan before cleaning.
- Remove the front grill by unsnapping the clips around the perimeter.
- Clean the fan blade, front and rear grills with a soft cloth moistened with a mild soap solution.
- Securely fasten the front grill to the rear grill by snapping the clips together over the perimeter.
FAN HEAD AND BASE CLEANING
Using a soft , moist cloth, with or without a mild soap solution, carefully clean the fan base and head. Use CAUTION around the housing area. Do not allow the motor or other electrical components to be exposed to water.
FAN STORAGE
- Store the fan in a clean, dry location between seasons or when not in use for an extended period of time.
- Keep the fan protected from dirt and dust during storage.
For inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility
WARRANTY INFORMATION
3 YEAR LIMITED WARRANTY
This device has a limited warranty of 3 years from the original date of purchase against workmanship and defects in material. If under normal use, your product fails to operate, please contact our customer service department at info@getholmesfans.com. A refund or replacement will be provided to you with proof of purchase. Star Elite Inc. may deny claims of damage caused by misuse or modifications of this product.
Warranty Service
Contact our customer service at www.getholmesfans.com/en/contact- us or info@getholmesfans.com or 1-866-769-3166 (8:30 am – 5:00 pm EST) Monday-Friday. Our team will be happy to assist.
© 2023 Sunbeam Products, Inc. All rights reserved.
HOLMES® is a registered trademark of Sunbeam Products, Inc. used under
license. Distributed by Star Elite Inc., Montreal, Canada H3B 3X9
SEH025-020823
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>