Jumbo 2124_1197105 Silicone Teats Instructions
- June 13, 2024
- JUMBO
Table of Contents
Jumbo 2124_1197105 Silicone Teats
Using Instructions
READ THESE INSTRUCTIONS AND KEEP FOR FUTURE REFERENCE FOR YOUR CHILD’S SAFETY AND HEALTH
WARNING/ CAUTION
- Always use this product with adult supervision.
- Never use feeding teats as a soother.
- Continuous and prolonged sucking of fluids will cause tooth decay.
- Always check food temperature before feeding.
Inspect before each use and pull the teat in all directions. Replace it at the first sign of wear or damage. In any case, it is advisable to replace at least every two months. Do not leave the teat in direct contact with sunlight or heat or leave it in disinfectant (sterilizing solution) for longer than recommended, as this may weaken the teat.
Check that the flow is suitable for the child’s needs, paying attention to any difficulties in sucking or leakage of milk from the mouth. Before first use, place in boiling water for 5 min. This ensures hygiene. Wash by hand before each use with warm water and dishwashing detergent and rinse thoroughly. When using bottle brushes, take care not to damage the delicate parts of the product (e.g. holes and valves on the teats). Sterilize before use. After each wash or sterilization, drain any excess liquid. The product can be cold sterilized in sterilizing solutions or hot sterilized (steam) using the appropriate equipment or by boiling for 5 minutes, avoiding contact with the metal walls of the container used. It is not advisable to use ultraviolet (UV) sterilizers. Store in a clean and dry place. Some brightly-coloured foods (e.g. tomato sauces) and drinks (e.g. tea, fruit juices) may alter the colour of the product.
For latex rubber teats: Produced from natural rubber latex which may cause allergic reactions. The product can be sterilized in an autoclave with 15 minute cycles at 121°C using distilled water as no additives are necessary. Do not exceed 10 sterilization cycles.
For silicone teats: The product can be sterilized in an autoclave with 15 minute cycles at 121°C using distilled water as no additives are necessary. Do not exceed 30 sterilization cycles. Please keep these use instructions for future reference.
COMPLIES WITH EN-14350
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>