Jumbo ad00_1197101 3M+ Silicone Baby Bottle Nipple Instructions
- June 13, 2024
- JUMBO
Table of Contents
SILICONE TEATS
READ THESE INSTRUCTIONS AND KEEP FOR FUTURE REFERENCE FOR YOUR CHILD’S SAFETY
AND HEALTH
WARNING! CAUTION!
- Always use this product with adult supervision.
- Never use feeding teats as a soother.
- Continuous and prolonged sucking of fluids will cause tooth decay.
- Always check food temperature before feeding.
Inspect before each use and pull the teat in all directions. Replace it at the
first sign of wear or damage. In any case, it is advisable to replace at least
every two months.
Do not leave the teat in direct contact with sunlight or heat or leave it in
disinfectant (sterilizing solution) for longer than recommended, as this may
weaken the teat.
Check that the flow is suitable for the child’s needs, paying attention to any
difficulties in sucking or leakage of milk from the mouth. Before first use,
place in boiling water for 5 min. This ensures hygiene. Wash by hand before
each use with warm water and dishwashing detergent and rinse thoroughly. When
using bottle brushes, take care not to damage the delicate parts of the
product (e.g. holes and valves on the teats). Sterilize before use. After each
wash or sterilization, drain any excess liquid. The product can be cold
sterilized in sterilizing solutions or hot sterilized (steam) using the
appropriate equipment or by boiling for 5 minutes, avoiding contact with the
metal walls of the container used. It is not advisable to use ultraviolet (UV)
sterilizers. Store in a dean and dry place. Some brightly — coloured foods
(e.g. tomato sauces) and drinks (e.g. tea, fruit juices) may alter the colour
of the product.
For latex rubber teats: Produced from natural rubber latex which may
cause allergic reactions. The product can be sterilized in an autoclave with
15 minute cycles at 121°C using distilled water as no additives are necessary.
Do not exceed 10 sterilization cycles.
For silicone teats: The product can be sterilized in an autodave with 15
minute cycles at 121°C using distilled water as no additives are necessary. Do
not exceed 30 sterilization cycles.
Please keep these use instructions for future reference.
COMPLIES WITH EN-14350
Documents / Resources
|
Jumbo ad00_1197101 3M+ Silicone Baby Bottle
Nipple
[pdf] Instructions
ad00_1197101 3M Silicone Baby Bottle Nipple, ad00_1197101, 3M Silicone Baby
Bottle Nipple, Silicone Baby Bottle Nipple, Baby Bottle Nipple, Bottle Nipple,
Nipple
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>