Jumpflex Hero Series Trampoline Anchor Kit Instruction Manual

: June 13, 2024
: Jumpflex

Table of Contents

Jumpflex Hero Series Trampoline Anchor Kit
Product Information
Product Usage Instructions
Parts List
Assembly Instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Jumpflex Hero Series Trampoline Anchor Kit

Product Information

Product Name: ANCHORKITTM Hero Series
Version: AK1.0
Manufacturer: Jumpflex
Contact Information:
- USA: Phone – 1866 305 7238, Website – www.jumpflex.com
- Canada: Phone – 1866 305 7238, Website – www.jumpflex.ca
- UK: Phone – 0330 010 4301, Website – www.jumpflex.co.uk
- New Zealand: Phone – 0800 586 735, Website – www.jumpflex.co.nz
- Australia: Phone – 1800 586 735, Website – www.jumpflex.com.au

Product Usage Instructions

Place the Bracket (1) in the center of the lower rail between two legs. Ensure that either side of the Bracket (1) touches the ground.
Insert the Peg (2) through the outer hole on the Bracket (1) at a 45-degree angle. Push or hammer the Peg (2) into the ground.
Insert the Peg (2) through the inner hole on the Bracket (1) at a 45-degree angle. Push or hammer the Peg (2) into the ground.
Repeat the above steps, placing the ANCHORKITTM assemblies on opposite sides of the trampoline.

Warning: The Jumpflex® ANCHORKIT™ is only a preventative measure and Jumpflex® does not claim or guarantee the ANCHORKIT™ will prevent your trampoline and or property from sustaining damage of any kind.
Warning: Wind conditions can change frequesntly, please take extra precautions if winds are strong.

Parts List

Jumpflex-Hero-Series-Trampoline-Anchor-Kit-1

Assembly Instructions

Place the Bracket (1) in the center of the lower rail between two legs. Ensuring either side of the Bracket (1) touches the ground.
Insert the Peg (2) through the outer hole on the Bracket (1) at a 45 degree angle. Push or hammer the Peg (2) into the ground.
Insert the Peg (2) through the inner hole on the Bracket (1) at a 45 degree angle. Push or hammer the Peg (2) into the ground.
Repeat the steps, placing the ANCHORKIT™ assemblies on opposite sides of the trampoline.