SEAFLO SFCBS-300-202 Single Circuit Battery Disconnect Switch Instruction Manual
- June 13, 2024
- SEAFLO
Table of Contents
SEAFLO SFCBS-300-202 Single Circuit Battery Disconnect Switch
Features
- Switches a single battery to a single load group
- Tin-plated copper studs for maximum conductivity and corrosion resistance
- Studs accept 3/8″ (M10) ring terminals
- The one-piece terminal stud design never loosens over lime
- Isolating cover with three snap-off side pieces protects rear contacts and allows wire access in any direction
Specifications
- Cranking Rating: 30 sec. 900ADC
- Intermittent Rating: 5 min. 500ADC
- Continuous Rating: 300A
- DC Terminal Stud, Tin-Plated Copper 3/8″-16 (M10)
- Torque 120 in-lb (13.56 N·m) Cable Size to Meet Ratings* Maximum Voltage Rating 4/0 AWG (120 mm2)
- Ignition Protected 48Volts DC
Regulatory
- CE, RoHS, ISO 8846
- Meets all American Boat and Yacht Council (ABYC) requirements for battery switches
- Meets UL 1500 and SAE J1171 external ignition protection requirements
- IP66- protected against powerful water jets
Caution
- Disconnect the positive battery terminal before installing.
- Consult electrical professionals for proper wiring application.
Installation
- Refer to the latest edition of NFPA 302 and/or ABYC E11 Standard for installation information.
- Attach one 4/0 AWG cable per tenminal to meet ratings.
- Battery cable terminals must be attached under the nut and lock washer. Torque 120 in-lb (13.56 N·m).
Operation
- Turn all appliances off before turning the battery switch to OFF.
- Do not switch to OFF while the engine is running.
Battery Switch Dimensions
Switch Mounting Options
Insulating cover removal
Cover breakout diagram
Apply steady pressure inwards
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>