Skylink WB-350 Garage Door Opener User Guide
- June 13, 2024
- SKYLINK
Table of Contents
Skylink WB-350 Garage Door Opener
A. Post-Installation Wiring
1. Re-connect the wires of the
safety beam sensor to the Atoms opener. Push in tab with a flat head screwdriver and insert the wires.
|
---|---
2. Re-connect the wires of the wall console to the Atoms opener. Push in tab with a flat head screwdriver and insert the wires.
|
B. Setup Travel Limit
1. Connect the opener to an approved power source. The dot in the LED display stays on.
|
---|---
2. Press and hold [Set] button for 5 seconds until the LED Display will show
the no “1”. Release the [Set) button.
3. Press the [ t] button until the door is in fully open position.
4. Press the [Set) button to confirm the door position.
|
5. The LED Display will show the no “2”.
6. Press the [ i] button until the door is in fully closed position.
7. Press the [Set] button again to confirm.
8. The LED light will flash 3 times when the travel limit settings are completed.
|
9. The LED Display will show the no “3”.
10. Press the Wall button to open the garage door to its fully open position.
11. The LED light will flash 3 times again.
| ****
12. The LED Display will show the no “4”.
13. Press the Wall button again to close the garage door to its fully closed position.
14. The LED Display will turn off.
| ****
c. Programming Remote Control
1. Press the [Set] button for one second, and release the button until the
LED Display shows the letter “P”.|
---|---
2. Program a Remote:
Within 2 minutes, press any button on the remote that you would like to program to the opener.
3. Program a Wireless Keypad:
Within 2 minutes, activate the keypad by entering:
a. Pin code [default O O O OJ plus # for single door operation.
b. Pin code [default O O O OJ plus [#] plus [Door No] for multiple door operation.
Enable the multiple-door operation mode: Enter the pin code plus 1) plus(9) plus{#].
|
4. Once the button on the remote is programmed. The LED segment will off and
emits one beep indicating the programming successfully.|
D. Erasing all the Remote Control from opener
Note : To erase any unwanted remote control, first erase all remotes.
- Press the [Set] button for 15 seconds, when the LED Display Flash “E”. Release the [Set] button.
- Press the [Set] button again to confirm erase all the programmed remotes.
- The dot in the LED Display stays on indicating the erasing successfully.
E. Operation
1. Wall Console
Push the button to open/close the garage door opener.
|
---|---
2. Remote
To open/close the opener with remote control, press the button that is programmed to the opener.
|
3. Keypad
3.1 1 Single Door Operation Enter the pin code plus [#] Example: 1 2 3 4 #
3.2 Multiple Doors Operation
Enter the pin code plus [#] plus [Door No.] Example: 1 2 3 4 # 1
| ****
Documents / Resources
|
Skylink WB-350 Garage Door
Opener
[pdf] User Guide
WB-350 Garage Door Opener, WB-350, Garage Door Opener, Door Opener, Opener
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>