SKYLINK WA-318T Wireless Water Alert Transmitter Instructions
- June 9, 2024
- SKYLINK
Table of Contents
Model WA-318T
Water Alert
INTRODUCTION
The Water Alert is designed to detect water overflow, water leakage, or rising
water, such as the water level of your bathtub. When water is detected, the
receiver will beep & flash. In this package, you should find a water sensor,
3V lithium battery and a clip.
Please follow the instructions below to set up the water sensor.
SET UP CODE CONNECTORS AND ZONE CONNECTORS
-
CODE CONNECTORS
In order for the sensor to communicate with the receiver properly, the sensor’s code must match with the receiver’s code. Code connectors 1 to 6 can be found by opening the top cover of the sensor and the back cover of the receiver. User is required to set these code connectors randomly and the code settings on the sensor and receiver must be the same. Each position of the code connector can be set to “+”, “-” or “0” position. Refer to the diagram below to set the code connectors properly. If the connector is placed on the top and middle posts, that column is set on “ + ”. If the connector is placed on the middle and bottom posts, that column is set on “ – ”. If the connector is removed completely, (not placed on any posts), it is set to “ 0 ”. (see diagram for examples of how to set a column to the three different positions).
Note: If you experience interference from
a nearby system, which could accidentally trigger your system, please change
the code settings on the sensor and receiver. The code setting on the sensor
and receiver should still match after changing the code setting. 2. SET UP
CODE CONNECTORS AND ZONE CONNECTORS (CONT) -
ZONE CONNECTORS
Each receiver can work with up to 4 different sensors (to represent 4 different zones on the receiver). There are 2 connectors that determine the zone number 1, 2, 3 and 4. These 2 connectors can be found by opening the top plastic cover, near the code connectors with marking “A” & “B”. Please follow table 1 to set the zone.
“+” in the table means the connec
tor for that position should be placed on the posts.
“-“ in the table means the connector for that position should be removed.
POWER UP THE WATER SENSOR
After setting up all the connectors, the sensor is now ready to be powered up.
Remove the top cover of the sensor and insert the 3V lithium battery to the
sensor as shown in the diagram. After inserting the battery to the water
sensor, the receiver will beep and the green LED on the receiver will stop
flashing and stay on. You can test the water sensor by submerging the sensor
portion in water.
Note: Only the sensor portion of the water sensor is waterproof, the
transmitter portion should never be submerged in water. When the sensor
portion becomes submerged in water, the receiver will beep and flash. The
beeping will continue until water cannot be detected. Put the top cover back
on and you are now ready to mount the water sensor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>