EUROM 362435 Manual Mica Heat Wave 2000 User Manual
- June 13, 2024
- EUROM
Table of Contents
EUROM 362435 Manual Mica Heat Wave 2000
This product is only suitable for well insulated spaces or occasional use.
Model: Mica Heat Wave 2000
Mandatory warnings
Please read and understand these safety instructions. Incorrect use can cause injury and will void EUROM’s warranty.
WARNING
- Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
- To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance of 1 m from the air outlet.
WARNING
In order to avoid overheating, do not cover the heater.
CAUTION
Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- Children of les than 3 years should be kept away unless continuously supervised.
- Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with appliance. Cleaning and user maintenance shall not be made by children without supervision.
- Heater must not be located immediately below a socket-outlet.
- Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Do not use this heater if it has been dropped.
- Do not use if there are visible signs of damage to the heater.
- Use this heater on a horizontal and stable surface.
- If the cord is damaged, it must be replaced by manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Do not use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
The device is equipped with an overheating protection, which switches it off automatically in case of internal overheating. Switch the device off, unplug the power plug, remove the source of overheating, let it cool down and use as normal. Do not use the device if the source of overheating cannot be traced or if the problem persists, but always contact your supplier.
General safety instructions
WARNING
- Prevent splashing water on or in the device.
- Do not immerse any part of the device in water or other liquids.
- Never insert fingers or other objects into the openings of the device.
- Do not expose the device to strong vibrations or mechanical stress.
WARNING
The device becomes very hot during use. Do not touch the device during use or within five minutes after use.
Safety during operation
WARNING
Do not use the device:
- outdoors or in a small space (< 7 m3 );
- lying or leaning;
- if any parts are dirty or wet;
- near large objects, like behind a door, under a shelf or cupboard;
- near a water source, like a bath, shower, swimming pool or open window;
- near or in a dusty and dirty environment, like a construction site;
- near flammable materials, liquids or fumes, like a shed, stable or green house;
- near other heat sources and open fire;
- immediately below a socket outlet;
- with an appliance that automatically switches the device on, such as a timer, dimmer or any other device.
If the device, the electric cable or plug shows damage or is malfunctioning, immediately take the appliance out of use and disconnect the power supply.
Warranty
EUROM offers a 3-year warranty on this device from the date of purchase. The warranty does not cover wear and tear from normal use. The warranty expires if a defect is the result of unintentional or careless use of the device. The manufacturer, importer and supplier are not liable for incorrect connections.
Introduction
Thank you for choosing this EUROM device. You have purchased a quality device that you will enjoy for many years. Using this device with respect and care will reduce the risk of personal injury or material damage.
CAUTION
It is important to read and understand this instruction manual before assembling, installing and using the device.
This manual describes the correct and safe use of this device. Keep this manual for future reference. The manual is an essential part of the device and must be given to the new owner upon resale or exchange. This manual has been compiled with the utmost care. Nevertheless, we reserve the right to improve and adjust this manual at any time. The images used may differ.
The following symbols and terms are used in this manual to alert the reader on safety issues and important information:
WARNING
Indicates a hazardous situation which, if the safety instructions are not followed, can lead to injuries to the operator or bystanders, light and/or moderate damage to the product or to the environment.
CAUTION
Indicates a hazardous situation which, if the safety instructions are not followed, can lead to light and/or moderate damage to the product or to the environment.
Identification
Specifications
Type: | Mica Heat Wave 2000 |
---|---|
Product size: | 73 x 34 x 62 cm |
Weight: | 4.46 kg |
Voltage: | 220-240V~ / 50-60Hz |
Power (L/H): | 1000W, 2000W |
Protection class: | Class I |
Description
The product is an easy-to-use electric heater for indoor use (Figure 2).
- Thermostat knob
- Control knob
- Control light
- Power plug
- Wheel (4x)
- Pedestal (2x)
Transport and storage
- Clean the device before storing it.
- Transport the device in an upright position.
- Store the device in an upright position, in its original packaging and in a cool, dry and dust-free area.
Assembly
WARNING
Plastic bags can be dangerous. To avoid danger of suffocation, keep this bag
away from babies and children.
The device is packed in one box. Remove all packaging material and check that the device is not damaged. Do not use the device if it is damaged, but always contact your supplier. Keep the packaging for safe storage and transport.
WARNING
The surface on which the device is placed must be made from non-flammable
material and should be able to withstand a minimum temperature of 125 °C.
WARNING
Never place the device on surfaces such as beds or deep-pile carpet as
openings could be blocked.
WARNING
Never use the device before it is correctly mounted.
-
Click the wheels (Figure 3, pos. 1) into the pedestals (Figure 3, pos. 2).
-
Screw and tighten the pedestals
(Figure 4, pos. 1) to the bottom of the heater (Figure 4, pos. 2) using the included screws (Figure 4, pos. 3).
Installation
WARNING
Do not insert the power plug into the wall socket before the device is
correctly mounted.
Do not use an extension cable; this can cause overheating and fire. If using
an extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 2000 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage matches the voltage indicated on the
identification label of the device. All electrical connections must stay dry
under all circumstances.
- Make sure the device is correctly mounted.
- Make sure the control knob is in the ‘0’ position (Figure 2, pos. 2).
- Insert the power plug into an earthed wall socket that is easily accessible. Use an earthed wall socket with a minimum power of 2000 Watt.
Operation
WARNING
Before every use, make sure that:
- you operate the device with dry hands;
- the device is clean and dry;
- the device is not damaged;
- the device is not covered or blocked;
- the device is safely installed.
CAUTION
When the device is turned on or off, it may emit a sound. This is the material expanding and shrinking during heating and cooling down.
- Turn the control knob (Figure 2, pos. 2) to the desired heating setting (1 or2).
- Heat setting 1: 1000W
- Heat setting 2: 2000W
- Turn the thermostat knob (Figure 2, pos. 1) clockwise to the desired temperature.
- Once the desired temperature is reached, turn the thermostat knob (Figure 2, pos. 1) anticlockwise until it clicks.
- The device will stop heating and the temperature is set.
- The device will automatically turn on and off to maintain the set temperature.
After operation
CAUTION
Do not use the power cable to unplug or carry the device. Do not wind the
power cable too tightly or in sharp corners. Do not wrap the power cable
around the device.
- Make sure the control knob is in the ‘0’ position (Figure 2, pos. 2).
- Disconnect the power plug from the power outlet.
- Let the device cool down before touching it.
- Wind the power cable.
Maintenance
WARNING
Do not perform any repairs or modifications to this device.
Maintenance and repairs must be carried out by a EUROM authorized professional. If the electric cable and/or electric plug is damaged, it should be replaced by the manufacturer, its service employee or persons with similar qualifications to prevent risks.
Cleaning
WARNING
This device becomes very hot. Make sure the device is turned off, unplugged
and completely cooled down before cleaning it.
CAUTION
When cleaning this device, do not use:
- scouring pads;
- hard brushes;
- flammable, aggressive or chemical cleaning products. Prevent water from entering the device. Do not immerse any part of the device in water or other liquids
It is recommended to clean the device after each use and prior to storage.
- Wipe the device with a damp, clean, soft, lint-free cloth or a soft brush.
- Use a vacuum cleaner to remove dust from the grilles.
- Let the device dry completely prior to use and storage.
Disposal
Correct Disposal of this product.
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
Information requirements for the electric local space heaters
Model identifier(s): Eurom Mica Heat Wave 2000
Item| Symbol| Value| Unit| Item| Unit
Heat output| Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat output| Pnom| 2,0| kW| manual heat charge control, with
integrated thermostat| No
Minimum heat output (indicative)| Pmin| 1,0| kW| manual heat charge control
with room and/or outdoor temperature feedback| No
Maximum continuous heat output| Pmax,c| 2,0| kW| electronic heat charge
control with room and/or outdoor temperature feedback| No
Auxiliary electricity consumption| fan assisted heat output| No
At nominal heat output| elmax| 0,000| kW| Type of heat output/room
temperature control (select one)
At minimum heat output| elmin| 0,000| kW| single stage heat output and no room
temperature control| No
In standby mode| elSB| –| kW| Two or more manual stages, no room temperature
control| No
| | | | with mechanic thermostat room temperature control| Yes
| | | | with electronic room temperature control| No
| | | | electronic room temperature control plus day timer| No
| | | | electronic room temperature control plus week timer| No
| | | | Other control options (multiple selections possible)
| | | | room temperature control, with presence detection| No
| | | | room temperature control, with open window detection| No
| | | | with distance control option| No
| | | | with adaptive start control| No
| | | | with working time limitation| No
| | | | with black bulb sensor| No
Contact details| Euromac BV – Kokosstraat 20 – 8281 JC – Genemuiden – The
Netherlands
Customer Support
Kokosstraat 20, 8281 JC Genemuiden, The Netherlands
T: (+31) 038 385 43 21 E: info@eurom.nl
I : www.eurom.nl
Model: Mica Heat Wave 2000 Date: 12/07/2023
Version: v1.0
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>