BLAUPUNKT GTx 1xxx Series 2-Way Coaxial Speaker Installation Guide

June 4, 2024
Blaupunkt

BLAUPUNKT GTx 1xxx Series 2-Way Coaxial Speaker

INTRODUCTION

Proper system planning is vital in order to maximize the device’s performance and road safety. Plan your installation carefully to avoid compromising performance reliability of the system. Consult an authorized Blaupunkt delaler for installation or reparation. Read the manual carefullt before operating the device for the first time.

Safety Notes

Ensure to folow below safety notes during installation and wiring connection:

  • Disconnect the negative terminal of the battery. Refer to the safety notes of the vehcle manufacturer.
  • Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
  • Ensure cross section of the cable is no less than 2.5mm2 if the positive and negative cables are too long.
  • Incorrect installation may result in malfunction of the device or the car sound system.

Installation and Connection Instructions

  • Select a dry and well-ventilated location to install the device.
  • The device must not be installed in overly exposed location such on therear shelf, rear seat etc.
  • The installation location must be suitable for screw holes and have stable ground support.

Voltage Supply

  • Use the supplied power extension cable to connect to the positive battery terminal.
  • Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.
  • The control of the device should be a two-channel control, either via the preamplifier output of the car sound system. A control solely via the right or left channel is also pos-sible since the low-frequency portion of the music is generally identical on both channels.

Disclaimer

In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products.

USA & CANADA:
This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada.

Recycling and Disposal

Do not dispose of your old unit in the household trash! Use the return and collection systems available to dispose of the old device. This manual may be updated from time to time without any notice.

SPECIFICATION

GTx 1352
Pair of 3.5” 2-way coaxial speaker with Polypropylene Cone Composition including mounting hardware

  • Max. Power Handling : 60W
  • Normal Output Power (RMS) : 20W Impedance : 4ohms
  • Frequency Response : 120Hz – 20,000Hz Sensitivity : 90±3dB
  • Mounting Depth : 41mm
  • Diameter Hole : 78mm

GTx 1402
Pair of 4.0” 2-way coaxial speaker with Polypropylene Cone Composition including mounting hardware

  • Max. Power Handling : 70W
  • Normal Output Power (RMS) : 22W
  • Impedance : 4ohms
  • Frequency Response : 100Hz – 20,000Hz
  • Sensitivity : 90±3dB
  • Mounting Depth : 47mm
  • Diameter Hole : 95mm

GTx 1662
Pair of 6.5” 2-way coaxial speaker with Polypropylene Cone Composition including mounting hardware

  • Max. Power Handling : 110W
  • Normal Output Power (RMS) : 33W
  • Impedance : 4ohms
  • Frequency Response : 70Hz – 20,000Hz
  • Sensitivity : 90±3dB
  • Mounting Depth : 56mm
  • Diameter Hole : 145mm

GTx 1692
Pair of 6.0” x 9.0” 2-way coaxial speaker with Polypropylene Cone Composition including mounting hardware

  • Max. Power Handling : 115W
  • Normal Output Power (RMS) : 35W
  • Impedance : 4ohms
  • Frequency Response : 60Hz – 20,000Hz
  • Sensitivity : 90±3dB
  • Mounting Depth : 74mm
  • Diameter Hole : 153mm x 220mm

INSTALLATION

If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist.

Problems Possible Causes Solutions
Speaker does not work Incorrect or loose wiring connection. Ensure proper

wiring connections of speaker.
Fraying or broken cables.| Repair or replace if the cables are damaged.
Speaker is damaged.| Replace with a new speaker.
Distorted and hissing sound| Voice coil or speaker cone is damaged.| Replace with a new speaker.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals