SOLIGHT WO784 Dimmable Outdoor Light Instruction Manual
- June 4, 2024
- Solight
Table of Contents
**SOLIGHT WO784 Dimmable Outdoor Light Instruction Manual
**
Introduction
Dear customer, thank you for purchasing our product. For its safe and full functioning, please read these instructions carefully and adhere to them to avoid product misuse or damage. Please prevent unauthorized use of this appliance and always observe all rules for using electric appliances. Keep these instructions for future reference. The installation must be performed by qualified personnel only. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Installation
- Switch off the power supply
- Open the luminaire, see Fig.1
- Make holes in the cover, see arrows in Fig. 2 1 4.
- Mark the holes on the wall
- Drill holes and insert dowels into them
- Push the power cable through the hole in the middle and screw the cover to the wall
- Connect the power cable to the terminal block
- Set the desired chromatically temperature with the switch and set
- Close the luminary and tighten the screws around the perimeter
- Switch on the power supply
Sensor settings
The sensor can be set by switching the pins with numerical markings. The pins are on in the upper position.
Distance settings
| 1 | |
|---|---|
| 100% | ON |
| 50% |
ON=
Disable =
Delay time settings
| 2 | 3 | |
|---|---|---|
| Ss | ON | ON |
| 1min | ON |
3min|
| ON
5min|
|
Light sensitivity settings
| 4 | |
|---|---|
| 25 1x | ON |
| Disable |
Specification
| Power | 20W |
|---|---|
| Voltage | 220 – 240 VAC |
| Luminous flux | 1800 lm |
| Chromaticity | 3000, 4000, 6000 K |
| Operation temperature | -20 °C – + 50 °C |
| Dimensions | 330 x76 mm |
| Protection class | IP65 |
| Detection angle | 120 ° |
| Detection range | max. 8 m (< 24 °C) |
| Lighting time range | 10±3s-5±1min |
| Light sensitivity | < 10 – 2000 lx |
Manufacturer
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>