CLAS AP 0080 Mini Fridge Servant Type 50l Instruction Manual

AP 0080 1 DRAWER TOOLBOX-FRIDGE 50l
SCHEMA

SPECIFICATIONS

The above specifications are subject to improvement.

SECURITY

1. This device uses AC220V/50Hz adapter, there should be a 500va stabilizer if the voltage fluctuation exceeds 198V-264V/50Hz.
2. The user should hold the plug when the power is off/on. Do not drag or pull the power cord.
3. Do not remove the power cord or plug.
4. Use a separate power outlet and grounded cables. Cables must not touch the gas and water pipes.
5. Never splash water directly on the product.
6. Keep away from dangerous and flammable goods such as ether, gas, alcohol, gunpowder, etc.
7. Keep away from spraying flammable materials such as paint, coating materials, etc.
8. Once the unit is turned off, it should not be restarted for 5 minutes.
9. Do not leave the power cord under heavy objects including the product itself.
10. Do not drill holes or install other objects on the cover.
11. This refrigerator is not suitable for storing pharmaceutical products.

STORAGE

1. Keep the unit upright when transporting it. The angle of the horizontal line must not exceed 50°, otherwise it will damage the compressor and affect the proper operation of the unit.
2. The unit must be placed on a firm and solid floor. Please remove the bottom pack to reduce shock and noise.
3. Keep at least 20cm distance between the back of the unit and the wall for ventilation, and keep a space with 160° opening angle for the door.
4. Keep the unit away from heat sources and avoid direct sunlight.
5. Never place the appliance in a place where water or high humidity can reach it. Splashes of water or dust should be cleaned up quickly using a soft cloth.
6. Do not place the product in freezing temperatures.

PREPARATION

1. Remove the carton and foam packaging (including the bottom foam) before use.
2. Clean the device before use.
3. After moving the appliance, wait 30 minutes before switching it on. On: close the door and connect it to the power source, turn on the lamp by the switch on the control panel, the lamp is on. After one and a half hours, the temperature inside should have dropped significantly, and this indicates that it is working properly.
4. After connecting to the power source, the unit should remain empty for one hour.

SETTING

1. Adjust the storage temperature via the temperature controller located inside the product (see photo), adjust the temperature according to the ambient temperature but also according to the contents to be cooled.
2. Please find the picture of the temperature adjustment button. The temperature adjustment capability is noted from “1” to “5”, adjust the storage temperature by turning the temperature controller clockwise. The higher the number, the colder the temperature. The knob can be turned as desired, except that we cannot turn it from “5” to “1” clockwise. The factory has set the temperature to “3”.
3. The «0» position indicates that the unit stops working.

STORAGE OF ITEMS

1. Do not put a lot of items in the appliance at one time, you must leave some space around the contents to allow fresh air to circulate inside the appliance. Keep bottled items away from the inside walls of the appliance, so that they do not freeze and break.
2. Do not put hot food directly into the appliance until it is cool inside the room. This will help to reduce energy consumption and extend the life of the compressor.

MAINTENANCE

Disconnect the power source before servicing the machine!

1. Keep the door seals clean, remove them from the door and clean them. Dry them and put them back as before. Putting a little talcum powder on the magnetic surface will help to prolong its life.
2. If there is heavy frost on the evaporator after a long period of use, remove all bottles from the unit, disconnect the power source, so the ice will melt automatically. Clean the water and reconnect the power supply.
3. Use a soft cloth and soak in water or soap (non-caustic, neutral detergent is also available) to clean the unit. Dry the unit after cleaning to prevent rusting.
4. Do not use any organic liquid, boiling water, lye or acidic solution to clean the appliance. Rinsing the appliance with water is not allowed and do not use hard brushes or steel brushes.
5. If the appliance is not going to be used for a long period of time, disconnect the power source, clean it by following the previous steps, wipe the water inside the appliance with a soft cloth.

PRECAUTIONS

1. The device is not suitable for the storage of blood, pharmaceuticals and biological products.
2. Do not place heavy products on top of the unit.

TROUBLESHOOTING GUIDE

plug and
reconnect it to the power source OR replace the fuse with a new one.
Abnormal compressor operation or humming| The supply voltage goes beyond the nominal range.| Disconnect the power source immediately and reconnect it when the voltage returns to normal. It is necessary to have a voltage stabiliser in case the power source is insufficient.
The compressor runs for a long time. but no frost on the surface of the evaporator.| Refrigerant system is faulty (leaking or blocked)| Contact a refrigeration repair service company.
There is frost or ice on the internal walls of the appliance and the internal temperature is too low.| The thermostat does not work.| Contact a refrigeration repair service company.
The internal temperature is too high and the compressor runs constantly.| Poor heat dissipation and ventilation of the coating. ambient temperature is too high| Improve ventilation and reduce room temperature.
Too much hot food was put in at the same time.| Remove food.
Door open frequently or for too long.| Reduce frequencies and shorten door opening times.
The noise is too loud.| The device is not level| Adjust the feet.
The closure of the device is too loose| Tighten the fastener.
The pipes touch the compressor.| Carefully separate pipes that touch each other

Warnings: Keep ventilation openings (in the appliance housing or in the built-in structure) free of obstructions.
Warnings: Do not use mechanical devices, or other means to accelerate the defrosting process.
Warnings: Do not use electrical devices inside the food storage compartment of the appliance.
Caution: Disassembly of the appliance by non-professional personnel is forbidden, as it involves risks.

ENVIRONMENTAL PROTECTION INFORMATION
At the end of its service life, this product must not be disposed of with household waste, but must be handed in to a collection point for the recycling of electrical and electronic equipment.
The symbol on the product, the operating instructions or the packaging indicates this.
The materials can be recycled in accordance with their marking. You are making an important contribution to environmental protection through recycling, material reuse or other forms of reuse of used appliances.
Please contact your municipality to find out which waste disposal facility is responsible.

CLAS Equipements
ZA de la CROUZA
73800 CHIGNIN
FRANCE
Tél. +33 (0)4 79 72 62 22
Fax. +33 (0)4 79 72 52 86
AP 0080
MINI FRIGO TYPE SERVANTE 50l
1 DRAWER TOOLBOX-FRIDGE 50l
If you need components or parts, please contact the reseller.
In case of problems, please contact your authorized technician.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>