Bambu Lab P1S 3D Printer User Guide

Bambu Lab P1S 3D Printer User Guide

Component Introduction

Accessory Specification

Tool Head Unlock

Remove the carboard from the tool head. Romove the foam from the excess chute.

Cut the zip tie securing the toolhead.

Spool Holder Assembly

Remove the screws as pictured with an Allen Key H2.

Attention: Please use the short end of the Allen Key to unlock the screws.

Hot Bed Unlock & Screen Installation

Remove the three screws with an Allen Key H2 to unlock the hot bed.

Insert the LCD cable into the port by plugging it into the terminal as pictured.

Attention: Bend the LCD cable towards the opening on the back of the screen as pictured.

Printer Binding

1. Download the Bambu Handy App. Register and log in to your Bambu Lab account.

Connect the printer to power. Follow the instructions on the screen until getting to the page shown on the right side.

Use Bambu Handy to scan the QR code on the screen, and bind your printer with your Bambu Lab account

DO NOT remove the protective foam from beneath the hot bed until after the initial calibration is complete
Select “N” and select a file to start the first print. We recommend using one of the pre-loaded files as a first test print. All the pre-loaded files can be printed with PLA Basic or PLA Matte.

Select ” pi”-” A “, and heat the nozzle to the recommended temperature for the filament. t Select ” 0 “-” E “-“iv” several times until the filament comes out from the nozzle and cannot be pulled out from the PTFE tube anchor manually.

Bambu Studio

Download Bambu Studio: https://bambulab.com/en/download/studio

Log in to Bambu Studio with your Bambu Lab account, which is the same for the Bambu Online store.
Create or open a project.

Bambu Studio

Slice the model, select your printer and send the model to print

Bambu Studio

During printing, you can remotely monitor your print, or pause/stop printing on the

Specification

Customer Support

Please visit the Bambu Lab Wiki for more setup and maintenance tutorials. https://wiki.bambulab.com/en/home

If you need support, please try either of the two approaches: Approach 1: Create a support ticket on the Official Website

Approach 2: Create a support ticket on the Bambu Handy App

Read More About This Manual & Download PDF:

References

• Bambu Lab | Unleash Your Creativity with Bambu Lab 3D Printers - Bambu Lab
• Software - Bambu Lab
• Software Studio - Bambu Lab
• Bambu Lab Wiki Homepage | Bambu Lab Wiki

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>