VISUAL COMFORT ARN 2480 Casoria 14 Inch Single Sconce Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
Casoria 14″ Single Sconce
Item # ARN 2480
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install it. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdriver
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture (E) by unscrewing screws (D).
-
Install mounting plate (B) to the junction box and secure it with mounting screws (C).
-
Install light bulbs into the sockets.
-
Attach glass panels (G) and rubber washers (H) to socket cup (F) and secure with screws (I) and caps (J).
NOTE: Do not overtighten otherwise shade could become damaged. -
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect the fixture hot wire (black) to the supply hot wire (usually black) using the wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (E) to mounting plate (B) and secure with screws (D).
Care Instructions : Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>