adidas ZNE 01 True Wireless Earbuds User Manual
- June 6, 2024
- adidas
Table of Contents
adidas ZNE 01 True Wireless Earbuds
OVERVIEW
GETTING STARTED
- Open the charging case.
- Press and hold the button on the bottom of the case until the LED turns to a slow blue pulse.
- Select adidas Z.N.E. 01 from your sound device’s Bluetooth® list.
TOUCH CONTROLS
Touch the left or right earbud to control audio and phone calls.
- ܟ touch to play/pause or receive/end a call
- touches to skip forward or reject a call
- touches to skip backward
CHARGING THE EARBUDS
Put your earbuds back in the case and close the lid to turn them of and begin
CHARGING THE CASE
Use a wireless charger or plug the case into a USB power source to charge it. The case is fully charged when the front-facing LED is steady green. To charge the case using a wireless charger, follow the instruction below.
- Place the charging case with its back flat against the wireless charging pad.
- Make sure that the front LED lights up to indicate that the case is charging.
- Once the LED light has turned steady green the case is fully charged.
PAIRING A NEW DEVICE
adidas Z.N.E. 01 remembers up to 6 previously paired devices and will try to reconnect if not connected, starting with the last connected device.
- Place the earbuds in the case and keep the lid open.
- Press and hold the button on the bottom of the case until the LED turns to a slow blue pulse.
- Select adidas Z.N.E. 01 from your sound device’s Bluetooth list. Note: The earbuds can be connected with one sound device at a time. Make sure to disconnect from the current device before reconnecting with a different device.
ADJUSTING THE EARBUD FIT
The earbuds silicone sleeve can be removed for a looser fit. To reatach the sleeve, simply pull the silicone sleeve over the earbud. Note : Make sure the holes in the sleeve are aligned with the sensors and ports on the earbud.
RESETTING THE EARBUDS
Place the earbuds in the case and close the lid to restart the earbuds. If the problem persists, perform a factory reset. Note : This will delete all user settings and the earbuds will need to be paired again.
- Place the earbuds in the case and keep the lid open.
- Press and hold the Bluetooth pairing button for 10 seconds, until the LED turns purple, to reset the earbuds to factory settings.
- Remove of adidas Z.N.E. 01 from your sound device’s Bluetooth list before pairing again. If the problem persists, perform a hardware reset. Note : This will delete all user settings and the earbuds will need to be paired again.
- Place the earbuds in the case and keep the lid open.
- Press and hold the Bluetooth pairing button for 15 seconds to reset the earbuds.
- Remove adidas Z.N.E. 01 from your sound device’s Bluetooth list before pairing again.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>