DFI ES220-CS 8th-9th Gen Intel Core Processors Installation Guide
- May 15, 2024
- DFI
Table of Contents
DFI ES220-CS 8th-9th Gen Intel Core Processors
Product Specifications
- Model: ES220-CS
- Manufacturer: DFI
- Slots: 2 M.2 slots, 2.5 SDD slots
- Additional Features: InnoAGE HDR1 pinout
Product Usage Instructions
Reversing the Case
Before installing internal devices, reverse the bottom of the case to the top.
CPU and Memory Installation
- Remove the three screws on each side of the box to install or replace the CPU and 2nd memory.
- Tilt up the case carefully after removing the screws.
- Once the upper case is removed, you will find 2.5 SDD slots/M.2 slots.
SO_DIMM2 Installation
- To install or replace the SO_DIMM2, remove the 4 screws around the 2.5 slots first, and tilt up the slot.
- Install the memory on the SO_DIMM2 slot once the slot is tilted up.
Board Rotation and Component Installation
- Remove the side case before rotating the board to the next side.
- Rotate the case, loosen the four screws marked in red, and tilt up the plate.
- After tilting up the plate, remove each screw marked in red located in each corner.
- Reverse the board by rotating the case again to install other components, including the CPU.
FAQ (Frequently Asked Questions)
-
Q: What are the available slots on the ES220-CS?
A: The ES220-CS comes with 2 M.2 slots, 2.5 SDD slots, and an InnoAGE HDR1 pinout on the board. -
Q: How do I install memory on the SO_DIMM2 slot?
A: To install memory on the SO_DIMM2 slot, first remove the 4 screws around the 2.5 slots, tilt up the slot, and then proceed with memory installation.
Product Layout
Installations
-
Before installing any internal devices, please reverse the bottom of the case to the top.
-
If you need to install or replace the CPU and 2nd memory, please also remove the three screws at each side of the box.
-
After the screws were removed in the last two steps, tilt up the case carefully.
-
After the upper case was removed, 2.5″ SDD slots / M.2 slots appeared.
-
Two M.2 slots and an InnoAGE HDR1 pinout are on the board.
-
To install or replace the SO_DIMM2, remove the 4 screws around the 2.5″ slots first, and tilt up the slot.
-
To install or replace the SO_DIMM2, remove the 4 screws around the 2.5″ slots first, and tilt up the slot.
-
Then you can install the memory on the SO_DIMM2 slot.
-
Before rotating the board to the next side, remove the side case first.
-
Rotate the case, loosen the four screws marked in red, and tilt up the plate.
-
After that plate was tilted up, remove each screw marked in red located in each corner.
-
Rotate the case again and reverse the board, then you can install other components including the CPU on the board.