fastrack FPods FZ100 Truly Wireless Earpods User Guide

fastrack FPods FZ100 Truly Wireless Earpods

Hey there,
Congratulations on getting your very own FPods FZ100 Truly Wireless Earpods with 3C NitroFast Charge, latest BT Version V5.0, Quad Mic ENC for crystal clear calls, 10mm deep bass drivers, 40ms ultra low latency gaming mode, and IPX5 rating. You can now truly sink into your world of sound. Your musical vibe begins here.

TRULY WIRELESS STEREO EARPODS WITH 3C NITROFAST CHARGE AND QUAD MIC ENVIRONMENTAL NOISE CANCELLATION

Included Components

Overview

Getting Started

• Place the earpods in the charging case and close the lid.
• Make sure to charge the earpods before starting the pairing process.
• Open the charging case lid and take out the buds.
• Turn ON your phone’s Bluetooth settings, and search for “Fods FZ100” and tap to pair and connect.
• Your earpods are now paired and ready for you to experience.
• The earpods will automatically reconnect to a previously paired device next time you use it (Make sure the device’s Bluetooth is ON).
• To charge the earpods, place them back into the case and close the lid.
• This will also power off the earpods.
• Use the right sized Eartips (S.M.L) for a better fit and experience.

Setup

• Power on: To turn on the earpods take them out of the case.
• Power off: Put the earpods in the case and close the lid to power off.
• To manually Power on the earpods, press and hold the buds for 3 seconds.
• To manually Power off the earpods, press and hold the buds for 5 seconds.
• To charge the earpods, place them in the charging case and close the lid.
• Please ensure to charge your earpods fully before using them.
• To charge the Charging Case, use the Type C charging cable provided in the box.
• Use a standard 5V / 1A adaptor for charging.

Reset

1. Take out the earpods from the Charging Case.
2. Unpair the earpods from the previously connected device.
3. Tap 5 times on L/R bud.
4. You will hear “Power Off” voice prompt.
5. Your earpods are now reset and ready to pair again.

FCC Warning

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1. This device may not cause harmful interference,
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>