fastrack FS100 F Pods Earphones User Guide
- June 9, 2024
- fastrack
Table of Contents
FS100 F Pods Earphones
User Guide
FS100 F Pods Earphones
Hey there,
Congratulations on getting your very own FPods FS100 Truly Wireless Earpods
with latest BT Version V5.3, Quad Mic ENC, 10mm deep bass drivers, 60ms low
latency gaming mode, and IPX4 rating. You can now truly sink into your world
of sound. Your musical vibe begins here.
Quick Start Guide
TRULY WIRELESS STEREO EARPODS WITH QUAD MIC ENVIRONMENTAL NOISE CANCELLATION
Included Components
Overview
Getting Started
- Place the earpods in the charging case and close the lid.
- Make sure to charge the earpods fully before starting the pairing process.
- Open the charging case lid and take out the buds.
- Turn ON your phone’s Bluetooth settings. and search for “FPods FS100” and tap to pair and connect.
- Your earpods are now paired and ready for you to experience.
- The earpods will automatically re-connect to a previously paired device the next time you use it (Make sure the device’s Bluetooth is ON).
- To charge the earpods, place them back into the case and close the lid. This will also power off the earpods.
- Use the right sized Eartips (S,M,L) for a better fit and experience.
Setup your FPods FS100
Setup
- Power on: To turn on the earpods take them out of the case.
- Power off: Put the earpods in the case and close the lid to power off.
- To manually Power on the earpods, press and hold the buds for 2 seconds.
- To manually Power off the earpods, press and hold the buds for 4 seconds.
- To charge the earpods, place them in the charging case and close the lid.
- Please ensure to charge your earpods fully before using them.
- To charge the Charging Case, use the Type C charging cable provided in the box.
- Use a standard 5V / IA adaptor for charging.
Reset
- Take out the earpods from the Charging Case.
- Unpair the earpods from the previously connected device.
- Tap 5 times on L/R bud.
- Red LED on both L and R buds blinks 3 times and goes off.
- Your earpods are now reset and ready to pair again.
Statement
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions,may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
Controls
Monopod Mode
You can take out any bud out of the Charging Case and start using it as
Monopod.
Features
Voice Assistant, Gaming Mode
Gaming Mode
Level up your gaming experience with the built-in low latency gaming mode.
Voice Assistant
Your voice assistant is just a few taps away.
Note – Remember to switch off gaming mode while listening to music for
the best audio experience.
| Environmental Noise Cancellation (Quad Mic)
---|---
| 40 Hours Playtime
| Leather Finish
| 10mm Driver
| Nitro Fast Charge – 10 min charge gives 150 min Playtime
| Gaming Mode (Low Latency of 60ms)
| Lightweight Earpods
| Latest BT version 5.3
As tested under optimal conditions at Titan Smart Labs.
LED Indications
Earpods
- Power ON: Blue LED blinks 3 times.
- Power OFF: Red LED blinks 3 times.
- Pairing Mode: Blue/Red LED blinks alternatively on I bud.
- Connected: LED off on both buds.
- While charging: Solid Red LED on buds during charging.
- Full charge: Buds LED goes off when fully charged.
Charging Case
- While charging: Red LED blinks continuously.
- Full charge: Solid red when fully charged.
Product Specifications:
- BT Version: V5.3
- Driver Size: 10mm
- Frequency Response: 20Hz — 20KHz
- Water Resistance: IPX4
- Total Playtime with Charging Case: 40 Hours
- Buds Charging Time: 45 min
- Case Charging Time: 75 min
- Charging Voltage: DC 5V
- Transmission Distance: 70m
- Earpods Battery Capacity: 40mAh
- Charging Case Battery Capacity: 300mAh
Care & Warrenty
The Dont’s
- Do not expose the earpods to extreme temperature/ weather conditions.
- Don’t use chemicals or detergent to clean your buds.
- Do not keep the case on charging for a longer time once it is fully charged.
Terms of Warranty
The product comes with a One year limited warranty against manufacturing
defects. T&C apply. Any damage to the earpods that is not a malfunctioning
issue will void the product’s warranty. Please take care of your buds to
ensure prolonged service life. If you have any queries or need to raise a
complaint, please call us on 1800-266-0123 or visit the nearest Fastrack
store.
Note – For more details on the product. please visit
www.fastrack.in
FCC Compliance
FCC ID: 2AK9F-FT8
FCC Compliance
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions.
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
**[www.fastrack.in](http://www.fastrack.in)
@fastrack
@fastrackworld
FCC ID: 2AK9F-FT8**
Documents / Resources
|
fastrack FS100 F Pods
Earphones
[pdf] User Guide
2AK9F-FT8, 2AK9FFT8, FS100 F Pods Earphones, FS100 F Pods, FS100 Earphones,
Earphones
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>