MP-HM1 18G HDMI Manager with EDID and HDCP Manage User Manual
- June 12, 2024
- MP
Table of Contents
MP-HM1 18G HDMI Manager with EDID and HDCP Manage User Manual
Product Introduction
The MP-HM1 is a 18G HDMI manager withEDID&HDCP manage. It supports up to 4K@60
4:4:4 and HDCP2.2. The product is power by
HDMI or USB-C, and it contains CEC block switch and support auto-downscaling.
Feature
- 18G HDMI 0 4K@60 444 HDCP2.2;
- Supports EDID & HDCP manage;
- Power by HDMI or USB-C;
- CEC block
Package
| l 1x MP-HM1 | l 1x User Manual |
|---|
Specification
Video Input
Input| (1) HDMI 2.0
Input Connector| (1) Female type-A
HDMI Input Resolution| Up to 4K@60 4:4:4
Video Output
Output| (1) HDMI 2.0
Output Connector| (1) Female type-A
HDMI Output Resolution| Up to 4K@60 4:4:4
General
Bandwidth| 18Gbps
Power Supply| 5V 1A
Power Consumption| 2.4W(MAX)
Dimension (WHD)| 54x18x60mm
Net Weight| 85g
Panel Description
- Power LED: The LED indicates green when power
- HDMI IN: HDMI2.0 input, connect to
- DIP Switch: 4-pin dip switch for EDID and HDCP
- USB-C: USB-C is used to power the machine, upload EDID and firmware
- CEC Switch: Turn on/off the CEC
- HDMI OUT: HDMI 2.0 output, connect to display
System Connection
EDID &HDCP management
Predefined EDID Setting
User Defined EDID Setting
- Rename the user defined EDID according the following format:
- Connect the machine to the PC with USB cable, the PC will automatically detect a U- disk named of “BOOTDISK”.
- Copy the EDID file into the U-disk, and then open the U-disk. If there is a SUCCESS. TXT file, it means that the EDID upload is
- Remove the USB cable, connect the adapter to power on the machine
HDCP management
| Switch Status | HDCP Function |
|---|---|
| 1 | Show a identify code to Source that no HDCP is supported by the device, |
then the source will assume that no HDCP is supported by the device and will send the content without HDCP encryption if the signal format allows it.
Firmware Upgrade
- Rename the upgrade file according the following format:
- Disconnect the HDMI and connect the MP- HM1 to the PC with USB cable, the PC will detect a U-disk named of “BOOTDISK”.
- Copy the file into the U-disk, and then open the U-disk. If there is a SUCCESS.TXT file, it means upgrade is successful, and if there is an TXT file, it means fail.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>