CRUX SWRTY-61S Wiring Interface Instruction Manual
- June 12, 2024
- CRUX
Table of Contents
CRUX SWRTY-61S Wiring Interface
PACKAGE CONTENTS
PRODUCT FEATURES
- Retains factory features in select Toyota vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognition (VR) feature from SWC on select radios.
- Supports BT-HF/A2DP/AVRCP profile on select aftermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- Retains factory Aux Input.
- EIA color coded wiring for easy installation.
PARTS INCLUDED
-
SWRTY-61S MODULE
-
SWRTY-61S HARNESS
-
SWC CABLE
INSTALLATION DIAGRAM
LED TROUBLESHOOTING ON MODULE
| LED LIGHT | LED MODULE FEEDBACK |
|---|---|
| BLUE LED OFF | NO POWER |
| RED LED FLASHES | WHEN PRESSING SWC BUTTONS |
DIP SWITCH SETTINGS
AFTERMARKET RADIO DIP SWITCH SETTINGS:
| RADIO BRAND: DIP: | 1 | 2 | 3 | 4 |
|---|---|---|---|---|
| Atoto, Dual, Farenheit, Jensen, Pioneer | OFF | OFF | ON | ON |
| Power Acoustik, Soundstream | OFF | OFF | ON | ON |
| Blaupunkt, Most o-brand Radios | OFF | OFF | ON | ON |
| Alpine | OFF | OFF | OFF | OFF |
| Clarion | OFF | ON | ON | OFF |
| Kenwood | OFF | ON | ON | ON |
| JVC | OFF | ON | OFF | ON |
| Boss, Old Sony | OFF | ON | OFF | OFF |
| New Sony | OFF | OFF | ON | OFF |
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most o-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
TOYOTA STEERING WHEEL CONTROL DIP SWITCH SETTING:
| DIP | 5 | 6 | 7 | 8 |
|---|---|---|---|---|
| Toyota | OFF | ON | OFF | ON |
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable and set the DIP switches to the aftermarket radio you are using.
NOTE: Insulate the Blue/Yellow wire or the 3.5mm plug if not being used.
For aftermarket radios that have wires for SWC connections, cut off the 3.5mm plug on the Crux SWC Cable and connect the SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case “shield” does not need to be connected.
VEHICLE APPLICATIONS
SCION
2005 – 2011 tC
2004 – 2007 xA
2004 – 2011 xB
2008 – 2011 xD
TOYOTA
2003 – 2013 4Runner
2005 – 2011 Avalon
2007 – 2011 Camry
2004 – 2008 Camry Solara
2007 – 2010 FJ Cruiser
2008 – 2012 Highlander
2005 – 2011 Matrix
2006 – 2011 RAV4
2003 – 2011 Sequoia
2004 – 2014 Sienna
2005 – 2012 Tacoma
2003 – 2013 Tundra (2013 early production)
2009 – 2011 Venza
2008 – 2011 Yaris
CUSTOMERS SUPPORT
Crux Interfacing Solutions • Chatsworth, CA 91311
phone: 818-609-9299 • fax:
818-996-8188 •
www.cruxinterfacing.com
