BUN-595-AA.23 Pulsar Electric BBQ with Cabinet Instruction Manual

June 12, 2024
Pulsar

BUN-595-AA.23 Pulsar Electric BBQ with Cabinet Instruction Manual
BUN-595-AA.23 Pulsar Electric BBQ with Cabinet

Pulsar Electric BBQ With Cabinet

  • Enamel Coated Steel Hotplate & Stainless Steel Grill
  • Cooking Surface: 410x 337 mm
  • 2000 Watt Output
  • 1.5m Power Cable
  • Dimensions – Lg82 x W473 x H991 mm

Grill & Hotplate

SAFETY WARNINGS

  • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Keep the appliance and its cord out of reach of children less than 8 years.
  • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Children should be supervised to ensure that they do not play with the appliance.
  • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
  • The connector must be removed before the appliance is cleaned and that the appliance inlet must be dried before the appliance is used again.
  • The temperature of accessible surfaces may be high when the appliance is operating.
  • Please check the device and the electrical wire timely, and stop using if you find some problems of the device.
  • Never immerse the appliance with heating element, the appliance should be switched off at mains when not in use.
  • Use only one appliance per plug and always use an earthed extension cable, with cross section of at least 1.0mm2
  • Do not touch the appliance (cover or grill plate) when cooking in order to prevent any risk of burning.
  • The temperature of the surface will be very high when using, please keep it away from tinder.
  • This appliance is only use for cooking.
  • Never place your appliance on a fragile surface.
  • Only the appropriate connector must be used.
  • The supply cord should be regularly examined for signs of damage, and if the cord is damaged, the appliance must not be used.
  • The appliance must be supplied through a residual current device (RCD) having a rated residual erating current not exceeding 30 mA.
  • The appliance is to be connected to a socket-outlet having an earthing contact.
  • Charcoal or similar combustible fuels must not be used with this appliance.

COMPONENT

Product Overawe

ASSEMEBLY INSTRUGTIONS

Ref Description Qty
1 Stainless steel grill 1
2 Hotplate 1
3 BBQ body 1
4 Left / Right side shelf 2
5 Cabinet left side panel 1
6 Cabinet right side panel 1
7 Fat tray panel 1
8 Cabinet door 1
9 Door handle 1
10 Cabinet front cross bar 1
11 Cabinet back panel 1
12 Cabinet bottom panel 1
13 Castors 4
14 Door magnet 1
15 Control knob 2
16 Left bracket 1
17 Right bracket 1
M4*10 10
M6*10 30
Spanner 1

Assembly steps:

step1:
Assembly Instructions

step2:
Assembly Instructions

M6*10 ¢m 3PCS

step3:
Assembly Instructions

M6*10 ¢m 3PCS

step4:
Assembly Instructions

6*10 ¢m 6PCS

stepb:
Assembly Instructions

M6*10 4PCS

step6:
Assembly Instructions

M4*10 8 PCS

step7:
Assembly Instructions

M4*10 2 PCS

step8:
Assembly Instructions

step9:
Assembly Instructions

step10:
Assembly Instructions

M6*10 4PCS

step11:
Assembly Instructions

M6*10 4PCS

step12:
Assembly Instructions

M6*10 5PCS

step13:
Assembly Instructions

step14:
Assembly Instructions

CLEANING

  • Unplug and leave the appliance to cool.
  • The connector must be removed before the appliance is cleaned and that the appliance inlet must be dried before the appliance is used again.
  • Wash the grids and griddle with a soft cloth or brush in warm and abluent water, but don’t wash it with abrasive.
  • Don’t spill the water on the device directly when cleaning, it may lead to conk out or get an electric shock

INSTRUCTION FOR USE:

  • Remove all packing materials from the outside and inside of the barbecue
  • Check that the voltage of your appliance is the same as your mains
  • Before each use ,unwind the flex completely
  • In case and extension cable is necessary, it must be earthed, and its cross section must be at lest 1.0 mm2. When using and extension cable, secure it safely so that people do not trip over it.
  • The appliance is equipped with an adjustable thermostat, when using it, position it on Max for pre-heating 10 minutes, then turn it to the position of your choice.
  • Itis normal that there is some smoke in the first time, which could protect the layer as to protect the device.
  • The appliance is suitable for outdoor use.

Environmental protection

CAUTION!
Electrical products must not be thrown out with domestic waste. They must be taken to a communal collecting point for environmentally friendly disposal in accordance with local regulations. Contact your local authorities or stockiest for advice on recycling. The packaging material is recyclable. Dispose of the packaging in an environmentally friendly manner and make it available for the recyclable material collection-service.

LIST OF SPARE PARTS

Part List
Part List

ASSEMBLY INSTRUCTIONS

PART NUMBER PART NAME SUPPLIER CODE
1 Hood handle E1HD0-01101-08080-076
2 Hood outer E1HD0-02301-10060-009
3 Left / Right side shelf E1TR0-00101-04080-009
4 Stainless steel grill E1BQ0-00301-33080-080
5 Hotplate E1BQ0-00201-04200-011
6 BBQ frame back panel E1BQ0-03701-04060-009
7 Heating wire support plate E1EG0-00801-10200-080
8 Electric heating wire E1EG0-00901-08000-080
9 Thermal reflection plate E1EG0-01001-10080-080
10 BBQ frame E1BQ0-02801-04060-009
11 BBQ front decoration part E1BQ0-02201-10060-080
12 Fascia E1BQ0-02301-10060-080
13 Control knob E1BQ0-02601-13000-082
14 power cord E1EG0-01401-32000-080
15 Fat tray panel E1BQ0-02001-05040-080
16 Cabinet front cross bar E1TR0-01501-10060-080
17 Cabinet right side panel E1TR0-01801-04060-009
18 Door magnet E1TR0-20201-13000-080
19 Cabinet left side panel E1TR0-01701-04060-009
20 Cabinet back panel E1TR0-01601-04060-009
21 Left bracket E1TR0-02001-04100-009
22 Right bracket E1TR0-02101-04100-009
23 Door handle E1TR0-04601–08080-076
24 Cabinet door E1TR0-14801-04060-009
25 Cabinet bottom panel E1TR0-01901-04060-009
26 Castors E1TR0-05501-13000-080
27 Bolt Pack BP-BUN-595

WARRANTY

Thank you for purchasing one of our quality Jumbuck BBQOs.

YOUR JUMBUCK BBQ IS COVERED AGAINST DEFECTS FOR A PERIOD OF 12 MONTHS FOR PARTS AND LABOUR, REPAIR OR REPLACEMENT.

THIS WARRANTY EXCLUDES SURFACE RUST AND DAMAGE CAUSED BY ABUSE OR NEGLECT.

CONDITIONS OF THE WARRANTY

  • The appliance must be operated and maintained in accordance with the instructions supplied in the operating manual.
  • Any repair does not extend the warranty period.
  • Any parts other than original Jumbuck parts will void this warranty.

Installation Conditions

  • A installations must conform to the applicable Gas, Electrical and Building standards as laid down by the local codes for state or region.
  • If the appliance is changed to natural gas (if applicable), it must be converted and installed by a licensed gas fitter.

FOR WARRANTY CLAIMS

The warranty for Australia is given by
Garth Australia Pty Ltd.
Suite 14 981 North Road, Murrumbeena, VIC 3163, AUSTRALIA
T :+613 8566 7660 F:+613 93917287 www.garthsupport.com

Garth Support website: www.garthsupport.com
or call: 1800 427 841
email: service@garth.com.au

  • The warranty for New Zealand is given by
  • Bunnings NZ Ltd
  • PO Box 14436,
  • Panmure, Auckland, 1741
  • NEW ZEALAND

Tel: 09 —9782200
Fax: 09-9782222
Email: OnlineEnguiries@bunnings.co.nz
Any claim under this warranty must
be made within 12 months of the
date of purchase of the product.
Proof of purchase must be presented.

For Australian Customers

To make a claim under the warranty please contact Garth support website: www.garthsupport.com or return the product (with proof of purchase) to any Bunnings store. (see: www.bunnings.com.au for store locations)

Garth Australia bears reasonable, direct expenses of claiming under the warranty.

The warranty covers manufacturer defects in materials, workmanship and finish under normal use.

This warranty is provided in addition to other rights and remedies you may have under law: our goods come with guarantees which cannot be excluded under the Australian Consumer Law. You are entitled to replacement or refund for a major failure and to compensation for other reasonably foreseeable loss ordamage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

The warranty excludes damage resulting from product misuse or product neglect. The warranty covers domestic use only and does not apply to commercial applications.

For New Zealand Customers

To make a claim under the warranty, take the product (with proof of purchase) to any Bunnings store (see www.bunnings.co.nz for store locations).

Bunnings NZ Ltd bears reasonable, direct expenses of claiming under the warranty. You may submit details and proof to our store for consideration.

The warranty covers manufacturer defects in material, workmanship and finish under normal use.

The warranty is provided in addition to other rights and remedies you may have under law: our goods come with guarantees which cannot be excluded under the Consumer Guarantees Act 1993 (NZ). You are entitled to replacement or refund for a major failure and to compensation for other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

The warranty excludes damage resulting from product misuse or product neglect. The warranty covers domestic use only and does not apply to commercial applications.

Goods presented for repair may be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the goods.

WHAT IS NOT COVERED IN THE WARRANTY

  • Removal or re-installation costs. This warranty does not cover costs for transit, nor in home service.
  • Liability will only be accepted for loss or damage during transit if at the time the product was being transported by
  • Bunnings or a Bunnings approved contractor.
  • Lack of maintenance, abuse, neglect, misuse, accidental or improper installation of this appliance.
  • Scratches, dents, corrosion or discoloration caused by heat, abrasive chemical cleaners or chipping of porcelain enamel parts.
  • Corrosion or damage caused by exposure to the elements such as insects, weather, hail or grease and fat fires.
  • Rusting of cast iron plates, grills and burners.
  • Cleaning and wear and tear; service calls of this nature are chargeable.
  • Commercial use of the product. Unauthorized repairs or modifications during the warranty period.
  • Glass breakage due to misuse or overheating
  • Consumable items, example – batteries.

RECORD THE FOLLOWING INFORMATION

  • Attach the copy of the purchase receipt here:—————————————
  • Date of Purchase….—————————-
  • Purchased From————————————
  • Location. —————————————–
  • Model Name and Number.—————————-
  • Serial Number.——————————————
  • Receipt Number.———————————-

Note: The serial number is located either on the outside of the packing carton or outside or inside the appliance.

FOR TECHNICAL ASSISTANCE

For Australia customers if you experience any technical issues with your Jumbuck BBQ, in the first instance review the instruction manual or contact the warranty service agent below.

For New Zealand customers if you experience any technical issues with your Jumbuck BBQ, in the first instance review the instruction manual or contact your local Bunnings warehouse.

FOR SPARE PARTS
Call your local Bunnings warehouse and ask them to order a part for you. You should provide the following information.

  • Model of BBO—————————————-
  • Year of purchase——————————————
  • Name of warranty service—————————————-
  • company above ————————————
  • Part that requires replacement—————————-
  • (refer to the list of spare parts in the————————————–
  • instruction manual)————————————————

Jumbuck Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals