SATECHI 200W USB-C 6-Port PD GaN Charger User Manual

SATECHI 200W USB-C 6-Port PD GaN Charger

PLUG & PLAY

1. Connect the charger to a power outlet.
2. Connect your devices.

FUNCTIONS

1. LED Indicator
2. 6x USB-C PD Charging Ports
3. CS Power Port
4. CS Power Cord (included)
5. Desktop Stand

POWER SCHEMATIC

IMPORTANT

• Only PD1 & PD2 ports will reach 140W charging rates with supporting host devices. Only one device can be connected at a time to either port in order to achieve 140W charging.
• When connecting devices to all six charging ports, connect your largest device to the PD1 port.
• Emark cables required to reach wattage over 60W
• Keep away from water, liquid, and moisture.

NEED HELP?

• +1 858 2681800
• support@satechi.com
• 7365 Mission Gorge Rd. Ste. G San Diego CA 92120 USA
• www.satechi.net

FCC

• This device complies with part 15 of the FCC results.
• Operation is subject to the following two conditions
  1. This device may not cause harmful interference and
  2. This device must accept any interference received, including interference that may cause undesired operation.
• Note: This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 7 5 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
  1. Reorient or relocate the receiving antenna
  2. Increase the separation between the equipment and receiver
  3. Connect the equipment into and outlet on a circuit different from that to which the receiver is connected
  4. Consult the dealer or an experienced radio/TV technician for help
• Changes or modifications not expressly approved by the manufacturer could void the user’s authority operate the equipment

CE DECLARATION OF CONFORMITY
Satechi declares that this product is in compliance with the essential requirements and other relevant provisions of applicable EC directives. For Europe, a copy of the Declaration of Conformity for this product may be obtained by visiting www.satechi.ne1/doc

WEEE Information

According to the WEEE (Waste Electrical and Electronic Equipment) Directive, do not dispose of this product as household waste or commercial waste. Waste electrical and electronic equipment should be appropriately collected and recycled as required by practices established for your country. For information on recycling of this product, please contact your local authorities, your household waste disposal service, or the shop where you purchased the product
CAN ICES-3 (B) I NMB-3 (B)
This Class B digital apparatus complies with Canadian ICES-003.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>