CAFE CKQBRSFNW2 Refrigeration Panel Accessory Instruction Manual

: June 12, 2024
: Cafe

Table of Contents

CAFE CKQBRSFNW2 Refrigeration Panel Accessory
Product Information
Installation Instructions
Documents / Resources

CAFE CKQBRSFNW2 Refrigeration Panel Accessory

Product Information

Matte White Side Panel Kit

The Matte White Side Panel Kit is an accessory designed for use with Cafe Appliances. It is used to enhance the appearance of your appliance by adding a matte white finish to the side panels. The kit includes adhesive strips and all necessary hardware for installation.

Warnings

Electrical Shock Hazard: Failure to follow the instructions can result in death or serious injury. Please ensure that you carefully follow all installation instructions.
Cut Hazard Warning: The panel edges along stamp/cut-out areas may be sharp. Avoid placing hands, fingers, or other appendages near these areas. It is recommended to wear gloves during installation to prevent cuts.

Installation Instructions

Before starting the installation, ensure that the power to the appliance is turned off to avoid any electrical shock hazards.
Clean the surface of the side panels to ensure proper adhesion of the adhesive strips.
Remove the backing from the adhesive strips and carefully apply them to the designated areas on the side panels.
Align the Matte White Side Panels with the side of the appliance and secure them in place using the provided hex screws.
Attach the top hinge cover to complete the installation.
Ensure that all components are securely fastened and that there are no loose parts.
Once the installation is complete, turn on the power to the appliance and verify that it is functioning properly.

For additional information and support, please visit cafeappliances.com. If you are located in Canada, please visit cafeappliances.ca.

Installation Instructions

WARNING Electrical Shock Hazard
Death or serious injury can result from failure to follow these instructions.
Disconnect power before installing this panel.
Replace all parts and panels before operating.
WARNING Cut Hazard Warning
Panel edges along stamp/cut-out areas may be sharp.
Avoid placing hands, fingers or other appendages near these areas. Wear gloves for installation. Failure to do so can result in cuts

INSTALL SIDE PANELS

Disconnect power from appliance before installing panel.
Remove the top case bumper by removing the hex screw (on some models).
Remove the paper from the adhesive strips on the side panels.
Loosen screws holding top hinge cover on the side of unit where panel will be installed. Slip panel under hinge cover.
Align the panels to the unit as shown.
Press with force on adhesive areas starting with the top front section to secure the panels.
Secure the top hinge cover and replace the rear case bumper (or install new one from kit).
Remove protective film by starting in the front/top corner and peeling downward toward the back/bottom corner.
Connect appliance to power.
For more information about this kit, visit cafeappliances.com. In Canada, visit cafeappliances.ca

Documents / Resources

| CAFE CKQBRSFNW2 Refrigeration Panel Accessory [pdf] Instruction Manual
CKQBRSFNW2 Refrigeration Panel Accessory, CKQBRSFNW2, Refrigeration Panel Accessory, Panel Accessory
---|---