CAFE CKQBLSFNW2 Matte White Side Panel Kit Instruction Manual
- June 4, 2024
- Cafe
Table of Contents
Matte White Side Panel Kit
Installation Instructions
CKQBLSFNW2 Matte White Side Panel Kit
For more information about this kit, visit cafeappliances.com. In Canada, visit cafeappliances.ca.
WARNING Electrical Shock Hazard
Death or serious injury can result from failure to follow these instructions.
- Disconnect power before installing this panel.
- Replace all parts and panels before operating.
WARNING Cut Hazard Warning
Panel edges along stamp/cut-out areas may be sharp. Avoid placing hands,
fingers or other appendages near these areas. Wear gloves for installation.
Failure to do so can result in cuts.
INSTALL SIDE PANELS
-
Disconnect power from the appliance before installing the panel.
-
Remove the top case bumper by removing the hex screw (on some models).
-
Remove the paper from the adhesive strips on the side panels.
-
Loosen screws holding the top hinge cover on the side of the unit where the panel will be installed. Slip panel under hinge cover.
-
Align the panels to the unit as shown.
-
Press with force on adhesive areas starting with the top front section to secure the panels.
-
Secure the top hinge cover and replace the rear case bumper (or install a new one from the kit).
-
Remove protective film by starting in the front/top corner and peeling downward toward the back/bottom corner.
-
Connect the appliance to power.
Printed in the United States
Documents / Resources
| CAFE
CKQBLSFNW2 Matte White Side Panel
Kit
[pdf] Instruction Manual
CKQBLSFNW2 Matte White Side Panel Kit, CKQBLSFNW2, Matte White Side Panel Kit,
Side Panel Kit, Panel Kit
---|---