olympia electronics RT-15-2 Electric Insecticide Instruction Manual
- June 12, 2024
- olympia electronics
Table of Contents
ELECTRIC INSECTICIDES
Instruction Manual
RT-15-2 Electric Insecticide
TECHNICAL CHARACTERISTICS | RT-1 5 | RT-1 5/2 | RT-1 5/6 | RT-1 5/7 |
---|---|---|---|---|
DESCRIPTION | Electric insecticide | Electric insecticide with mirror | ||
OPERATION VOLTAGE | 220-240VAC/50-60Hz | |||
MAXIMUM POWER CONSUMPTION | 270VA | 150VA | 270VA | |
FLUORESCENT LAMP | 3x36W BL | 2x36W BL | 3x36W BL | |
GRID VOLTAGE | 3.5kV | |||
DEGREES OF COVER PROTECTION | IP 20 | |||
PRODUCED IN ACCORDANCE WITH | EN 60335-1, EN 60335-2-59 | |||
OPERATION TEMPERATURE RANGE | 0 to 60 °C | |||
RELATIVE HUMIDITY | Up to 95% | |||
CONSTRUCTION MATERIALS | Bayblend FR3010, electrostatic painted aluminum | |||
EXTERNAL DIMENSIONS | 1250 x 140 x 480 mm (L x W x H) | |||
TYPICAL WEIGHT | 13.6kgr. | 12.9kgr. | 13kgr. | 13.7kgr. |
GUARANTEE | 2 years (1 year for the lamps) |
Thank you for your trust in our products Olympia Electronics – European manufacturer
IN GENERAL
The device was created to exterminate all disturbing insects. The special
fluorescent tubes (Black Light) attract insects from a long distance. For this
reason it could be used in every place that many insects exist. They are
attracted and pass though the interior metal net, they are exterminated by
high voltage. There is an exterior net in order to protect birds, animals or
human beings that are close enough.
Without using any chemical material it offers a complete protection again stay
insects like mosquitos, flies, tiny gnats etc. There is a special drawer at
the bottom side of the device where all dead insects are collected. To remove
the drawer unscrew the retaining screw.
WARNING!!!
Before removing the drawer follow carefully the below steps.
a. Remove the plug of the mains.
b. Unscrew the retaining screw of the drawer.
c. Remove the special drawer, clean the drawer and re- install it. Then screw
again the retaining screw and reconnect the device on the mains.
In case of changing the lamps or the starter, follow carefully the below
steps.
a. Remove the plug of the mains.
b. Unfasten the retaining screws and remove the protective exterior net.
c. Replace the tube or the starter which is worn.
d. Reinstall the protective exterior net and fasten the removed screws.
e. Finish reconnecting the device on the mains and it is ready to operate.
ATTENTION!!! When the device is operating the protective exterior net
must be installed.
Installation
Just plug the apparatus to the mains and it is ready for operation.
It is placed in a clear and visible place so as to attract insects easily .
It includes two hooks on top side for ceiling mounting installation using a
chain. The RT15 and RT-15/2 are suitable for hospitals, army camps, factories,
etc.
The models RT-15/6 and RT-15/7 are special models with a mirror for wall-
mounting installation. The connection is the same as previously. The
installation is as follows.
First remove the screws 1A and 1B(Figure 1) which are found at the upper side-
wise and replace them with the plastic holders.
Afterwards install the apparatus on the wall.
Finally place the plastic holders at point 2A and 2B (Figure 1) and fix it on
the wall.
Description
- Hole (for wall-mounted installation).
- Hole (for wall-mounted installation).
- Special drawer.
- Installation point (for normal installation with chain).
- Fuse holder.
- Plug.
- Protection grid.
WARNING!!!
- The device is suitable for internal installation.
- The device must be kept away from children.
- The device must be not installed in areas with combustible gases or explosive dust.
- The device is not suitable for use in Sheds, cottages, stables and likewise places.
- If the device’s cable is worn or damaged it must be replaced from OLYMPIA ELECTRONICS SERVICE department.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the
goods. The period of warranty is specified in the official catalogue of
Olympia Electronics and also in the technical leaflet, which accompanies each
product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia
Electronics or if the buyer modifies the goods provided or has any repairs or
re-setting done by a third party, unless Olympia Electronics has fully agreed
to them in writing. Products that have been damaged can be returned to the
premises of our company for repair or replacement, as long as the warranty
period is valid.
Olympia Electronics reserves the right to repair or to replace the returned
goods and to or not charge the buyer depending on the reason of defection.
Olympia Electronics reserves the right to charge or not the buyer the
transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerina
P.C. 60300 P.O. Box 06 Εginio Pieria’s Greece
www.olympia-electronics.com
info@olympia-electronics.gr
925015000_09_010
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>