NEEWER RT116 Remote Shutter Instruction Manual
- June 12, 2024
- NEEWER
Table of Contents
NEEWER RT116 Remote Shutter
Product Information
The device is designed to meet general RF (Radio Frequency) exposure requirements. It is important to note that this equipment should be installed and operated while maintaining a minimum distance of 0mm between the radiator (antenna) and your body.
Product Usage Instructions
- Ensure that the device is properly installed according to the manufacturer’s guidelines.
- Before using the device, make sure that there is no physical obstruction or interference around the radiator (antenna).
- Maintain a minimum distance of 0mm between the radiator and your body while operating the device.
- Follow any additional safety instructions mentioned in the user manual for optimal usage.
Please note that maintaining the recommended distance between the radiator and your body helps minimize RF exposure. It is important to adhere to these guidelines for safe and appropriate use of the device.
Product illustration
- Smart phone OS update or change in the future might lead to imcompatible
Replace thc battery
Using a coin or other open tool, rotate the battery cover to the left until it unlocks.
- positive pole upwards to install the battery.
WARNING!
Incorrect rotation position will cause the lid opening to fail.
Instructions for use
Easy to set up, Easy to use
Paring
- Turn on the shutter by switching the on/off button, the shutter will enter into pairing mode and indicator LED starts flash quickly at the same time.
- Activate the function on your phone and sourcing the devices around.
- Select the device of “NEEWER-Shutter” from the list and paring will be finished autonmaticaly in few seconds.
Product Specifications
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: The user is cautioned that changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructlons, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: Reorient or the
receiving antenna. Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected. Consult the dealer or an experienced radio/TV
technician for help.
FCC RF Radiation Exposure Statement:
- This Transmitter must not be co-located or operating in conjunction with any Other antenna or transmitter.
- This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
The device has been evaluated to meet general RF exposure requirement. The devlce can be used in portable exposure condition without restriction.
WARNING
KEEP OUT OF REACH OF CHILDREN
Lithium button/coin battery is included. Swallowing can lead to chemical
burns,perforation of soft tissue, and death_Severe burns can occur within 2
hours of ingestion. Seek medical attention immediately.
IC Warning Statements
“This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). This radio transmitter has been approved by Industry Canada to operate with the antenna types listed with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximur gain indicated for that type, are strictly prohibited for use with this device. The device has evaluated to meet general RF exposure requirement. This equipment should be and operated with minimum distance Omm between the radiator & your body
If you have any questions about product , we are glad to help.
- US +1732-623-9777
- UK +44 (0) 3330113494
- Send us an email
- [email protected].
- www.neewer.com.
- www.neewer.com.
- UK IREP
- Lingfeng Electronic (I-JK) Ltd International House, 10 Churchill Way, Cardiff, CFIO 2HE, United Kingdom
- EC REP
- NW Formations GmbH(for authorities only) Hoferstrasse 9B, 71636 Ludwigsburg, Germany
- Shenzhen Neewer Technology Co.,Ltd.
- Room 1903, Block A, Lu Shan Building No. 3023 Chunfeng Rd Luo Hu District, Shenzhen Guangdong 518001, China