ITC 86402 Solar Assist Handle Instruction Manual
- June 12, 2024
- ITC
Table of Contents
86402 Solar Assist Handle
Instruction Manual Attune™ Solar Assist Handle
Part#: 86402
INSTALLATION INSTRUCTIONS
PARTS/TOOLS NEEDED:
IMPORTANT SAFETY INSTRUCTIONS
READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
- Make sure there is strong support structure behind the handle. Failure to install into adequate support will void the warranty and runs the risk of pulling the handle out of the wall.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Battery will last up to 60 hours on a full charge. Brightness and intensity will decrease over time. Note, partial sunlight or shaded areas will not achieve a full charge on the battery.
- Only use rechargeable NiMh batteries, lead acid batteries will melt or explode in the sun.
1. Determine installation location, mark screw holes and drill pilot holes.
2. If
installing the solar handle, remove the battery protector and insert the
battery into the solar cell box. Slide the solar box into the opening with the
LEDs facing toward the unit. 
3. Screw in handle and snap decorative end caps over the
ends. 
For warranty
information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00226 • Rev B • 07/15/2023
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>