Intellitronix MS9107B LED Digital Transmission Temperature Gauge Instructions
- June 12, 2024
- Intellitronix
Table of Contents
Intellitronix MS9107B LED Digital Transmission Temperature Gauge
Thank you for purchasing this instrument from Intellitronix. We value our customers!
- Always disconnect the battery before attempting any electrical work on your vehicle.
KIT COMPONENTS
- One (1) LED Gauge
- One (1) S8013 temperature sender
WIRING INSTRUCTIONS
Note: Automotive circuit connectors are the preferred method of connecting wires. However, you may solder if you prefer.
Ground – Black Connect directly to an engine ground such as the engine block. For the most accurate readings, connect to the same ground as the sending unit.
Power – Red Connect to a switched +12V source such as the ignition switch.
Dimmer – Purple Connect to the parking lights to dim the LEDs 50% when the headlights are on. However, do not connect to the headlight rheostat control wire; the dimming feature will not work properly. Otherwise, connect to ground for permanent 100% brightness.
Temperature – Blue Connect to the output of the temperature sending unit.
Part Number: M9107
Made in America
Lifetime Guarantee
Documents / Resources
|
Intellitronix MS9107B LED Digital Transmission Temperature
Gauge
[pdf] Instructions
MS9107B LED Digital Transmission Temperature Gauge, MS9107B, LED Digital
Transmission Temperature Gauge, Digital Transmission Temperature Gauge,
Transmission Temperature Gauge, Temperature Gauge, Gauge
---|---