Go Power GP-ISW-200 Industrial Pure Sine Wave Inverter User Guide
- June 12, 2024
- Go Power
Table of Contents
Go Power GP-ISW-200 Industrial Pure Sine Wave Inverter User Guide
Find tech tips, manuals and support at gpelectric.com
PRODUCT SPECIFICATIONS
Note: Both 12V and 24V inverter specifications are listed below.
WARNINGS
Do not open or disassemble the Inverter. Attempting to do so may cause risk of
electrical shock or fire.
We guarantee this product against defects in materials and workmanship for a
period of 24 months from date of purthase. In case you need to repair or
replace any defective power inverters, please contact your local Go Powerl
distributor.
This warranty will be considered void if the unit has been misused, altered, or accidentally damaged. Go Power! is not liable for anything that occurs as a result of the user’s fault.
Please read the Owner’s Manual BEFORE connecting to the supply.
You can view and download the manual at
https://gpelectric.info/lSW200400Manual
INSTALLATION AND WIRING – OVERVIEW
The GP-ISW should be located as close to the batteries as possible but not within the same compartment. The length and size of the DC Cables will affect performance. Long DC wires tend to lose efficiency and reduce the overall performance of the Inverter/Charger.
For optimum Inverter performance the GP-ISW must be installed so the front and rear air vents are not blocked or obstructed in any way. Do not install the GP-ISW in an area with limited air flow. Allow as much space around the Inverter as possible, leaving at least 4 inches of airspace clearance around all ventilation areas.
TOOLS AND MATERIALS NEEDED
- Flathead Screwdriver (for wire terminals)
- Philips Screwdriver (for mounting screws)
MOUNTING ORIENTATIONS
LED INDICATORS
INPUT VOLTAGE LEVEL
See user manual for complete instructions at gpelectric.com
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>