MOUNTUP MU1002 Free Standing Dual Monitor Stand Instruction Manual
- June 12, 2024
- MOUNTUP
Table of Contents
Free Standing Dual Monitor Stand
**Instruction Manual
**
If you have any questions , please contact us.
V2.0
WARNING!
If you do not understand these instructions or have doubts about the safety of
the installation, assembly or use of this product, please contact us.
Before starting assembly, verify all parts are included and undamaged.
Improper installation may cause damage or serious injury. Do not use this
product for any purpose that is not explicitly specified in this manual. Do
not exceed weight capacity. We cannot be liable for damage or injury caused by
improper mounting, incorrect assembly or inappropriate use.
This product contains small items that could be a choking hazard if swallowed.
NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
NOTE: Not all hardware included will be used.
DO NOT EXCEED WEIGHT CAPACITY.
ASSEMBLY STEPS
STEP 1: Pole Installation
Use the 4mm Allen Key (J) to tighten the screws (F) into the pole (D) from the
bottom of the base (C).
STEP 2: Arm Installation
Install wire clip (E) and swivel arm (B) to the pole (D). Fasten the bolt with
supplied 6mm Allen key (K).
Attached the wire clips (G) to the swivel arm (B).
STEP 3: Attach Monitor
OPTION A: Flat Back Monitor
For flat back monitor, secure VESA plate (A) to monitor using screws (M-A or
M-C) and washers (M-E). CAUTION:To select the correct bolts(M-A or M-C)
for your monitor, you can try to screw it on your monitor by hand. The one can
screw inside is the correct bolt for your monitor.
OPTION B: Curved Back Monitor
For monitor with curved or recessed back, align spacers (M-F) with mounting
holes in monitor, and secure VESA plate (A) to monitor using screws (M-B or
M-D) and washers (M-E).
STEP 4: Hang Monitor
Slide the monitor onto the head of swivel arm (B). Install the plastic cover
(H) and security bolt (I).
Tighten the bolt with the supplied 4mm Allen key (J). Make sure the security
bolt (I) is installed before you rotate the monitor.
STEP 5: Tilt Adjustment
Tighten the bolt with the supplied 6mm Allen key (K) to fix the tilt angle.
**** Refer to below illustrations to adjust tilting angle of your monitor.
Note:
- Loosen the tilting bolt.
- Adjust monitor to your desired tilting angle.
- Retighten the tilting bolt to fix the tilting angle.
STEP 6: Cable Management
Manage cables and store Allen keys (J,K) in wire clip (E) for future use.
Adjust as Desired
Adjust monitor position and rotation.
For minor height adjustment, turn the plastic cover (H) with the supplied 6mm
Allen Key (K) to raise or lower the monitor. Ignore this step if the two
monitors are level.
Note: When tilted, if the monitor sags or does not stay, please fasten the tilting bolt on the mount until the monitor can be held at any angle as needed.
Product Dimensions
**** CAUTION AND MAINTENANCE:
- Never allow children to climb, stand, hang, or play on any part of monitor or stand.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
If you have any questions, please contact us.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>