hyco CPURE Crystal Pure Water Tap Installation Guide
- June 12, 2024
- hyco
Table of Contents
hyco CPURE Crystal Pure Water Tap
Product Information
- Product Name: CPURE Crystal Pure
- Model Number: v22.12.4
Product Usage Instructions
- Start by assembling the tap body (1) and tap base (2) together.
- Place a large black rubber washer (3) onto the tap body (1) and another one onto the tap base (2).
- Take a large steel washer (5) and slide it onto the tap base (2).
- Insert the assembled tap body and base into the desired installation location.
- Secure the tap assembly by tightening the hex nut (6) onto the threaded end of the tap body (1).
- If your installation requires a push-fit pipe connection, use the provided push-fit pipe connector (7) to attach the water supply pipe to the tap assembly.
Note: Ensure all components are tightly secured during
installation to prevent leaks or damage.
Product Installation Guide
CPURE
Crystal Pure
v22.12.4
Can be fitted into any existing hole (up to a max of 35mm diameter and up to
45mm thickness).
If a new hole is required, the tap can be fitted into a minimum 12mm diameter
hole.
Take the tap and tap base (including the large black rubber washer) and insert
into the hole of the mounting surface.
Ensure tap is in the desired orientation.
On the underside of the mounting surface place the large black rubber washer
followed by the large steel washer over the thread before using the hex nut to
fix the tap firmly into place.
The push fit pipe connector will facilitate connection to 1/4″ tubing (supplied with filter).
- Tap body
- Tap base
- Large black rubber washer
- Large black rubber washer
- Large steel washer
- Hex nut
- Push fit pipe connector