NATIONAL INSTRUMENTS PXI-1031 Chassis Handle Feet Kit Installation Guide
- June 12, 2024
- NATIONAL INSTRUMENTS
Table of Contents
NATIONAL INSTRUMENTS PXI-1031 Chassis Handle Feet Kit
Product Information
The NI PXI-1031 is a chassis handle and feet kit designed for the NI PXI-1031 chassis. This kit includes a chassis handle, COAlabel plate, rubber feet, and M4 shoulder screws. It is used to enhance the portability and stability of the NI PXI-1031 chassis.
Product Usage Instructions
- Ensure that the NI PXI-1031 chassis is powered off and disconnected from any power source.
- Locate the chassis handle (Qty. 1) included in the kit.
- Attach the chassis handle to the designated handle slots on the NI PXI-1031 chassis. Ensure that it is securely fastened.
- Locate the COA label plate and position it on the chassis according to your preference. This plate can be used to display important information or labels.
- Take the rubber feet (Qty. 4) and attach them to the bottom corners of the NI PXI-1031 chassis. Make sure they are aligned properly and provide stability to the chassis.
- Use the M4 shoulder screws (Qty. 4) to secure the rubber feet in place. Tighten them appropriately to ensure a secure fit.
- Once all components are properly installed, verify that they are securely attached to the NI PXI-1031 chassis.
- You can now power on and use the NI PXI-1031 chassis with the installed handle and feet kit for improved portability and stability.
Note: Refer to the NI PXI-1031 user manual for additional information on operating and maintaining the chassis.
INSTALLATION
To install the kit, complete the following steps.
- Remove COA label plate (as required).
- Install the four rubber feet using four M4 shoulder screws.
- Install the handle as shown using four M3 × 10 panhead screws.
Note You can install the handle/feet kit on either side of the chassis
.
- Chassis Handle (Qty. 1)
- M3 × 10 Panhead Screw (Qty. 4)
- COA Label Plate
- Rubber Feet (Qty.4)
- M4 Shoulder Screws (Qty. 4)
INSTRUCTION GUIDE
National Instruments™, NI™, and ni.com™ are trademarks of National Instruments Corporation. Product and company names mentioned herein are trademarks or trade names of their respectivecompanies. For patents covering National Instruments products, refer to the appropriate location: Help» Patents in your software, the patents.txt file on your CD, or ni.com/patents. © 2004 National Instruments Corp. All rights reserved. 370995A-01 Feb04
References
- Test and Measurement Systems, a part of Emerson - NI
- PXI-1031 National Instruments Chassis | Apex Waves
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>