BRESSER 4321500 Spotting Scope Instruction Manual

4321500 Spotting Scope
Instruction Manual

Art. No.: 4321500 / 4322000 / 4334500

4321500 Spotting Scope

WARNING!
Never look directly into or close to the sun with this device. DANGER OF BLINDNESS!

Warranty & Service

Parts

1. Eyepiece / Rubber eyecups
2. Zoom
3. Focus wheel (fine adjustment)
4. Optical tube
5. Tripod adapter thread
6. Main tube clamp
7. Fastening screw
8. Sunshade

Setting up the spotting scope
Ideally the spotting scope should be on a tripod of suitable loadbearing capacity (obtainable as a Bressler accessory). Your spotting scope has a tripod thread to DIN standard (5). It can therefore be attached to any tripod with a DIN standard thread.
Important:
Remove the protective caps from the main tube and eyepiece. Make sure they are reinserted after every use.
Controls

• Focus wheel: Look into the eyepiece (1) and rotate the focus wheel (3) in either direction to focus on an object.
• Zoom: Rotate the zoom control (2) to zoom in or out on an object; then use the focus wheel (3) to refine the focus.
• Moving the main tube: These spotting scopes have a main tube clamp (6) and fastening screw (7). Turn screw (7) counterclockwise to undo the main tube clamp. You can then turn the entire main tube (4) about its own axis and thus vary the eyepiece (1) position. To fasten the main tube in the desired position turn the fastening screw clockwise.
• Indoor Viewing vs. Outdoor Viewing: Although you may casually observe through an open or closed window, the best observing is always done outdoors. Temperature differences between inside and outside air, and the low quality of window glass can blur images through the spotting scope.
• Sun shield: Extend the sun shield (9) in strong sunshine affecting visibility. Put your hand around the spotting scope aperture ring and simply push the shield out.

Terrestrial Observing

When viewing land objects, you will be observing through heat waves on the earth surface. You may have noticed these heat waves while driving down a highway during the summer. Heat waves cause a loss of image quality.
If heat waves interfere with your viewing, try focusing at low power to see a steadier, higher quality image. Observe in early morning hours, before the earth has built up too much internal heat.

Cleaning and Maintenance

Your spotting scope is a precision optical instrument designed for a lifetime of rewarding viewing. It will rarely, if ever, require factory servicing or maintenance. Follow these guidelines to keep your spotting scope in the best condition:

• Avoid cleaning the spotting scope’s lenses. A little dust on the front surface of the spotting scope’s correcting lens will not cause loss of image quality.

• When absolutely necessary, dust on the front lens should be removed with very gentle strokes of a camel hair brush or blown off with an ear syringe (available at most pharmacies).

• Fingerprints and organic materials on the front lens may be removed with a solution of 3 parts distilled water to 1 part isopropyl alcohol. You may also add 1 drop of biodegradable dishwashing soap per pint of solution. Use soft, white  facial tissues and make short, gentle strokes. Change tissues often.
  CAUTION: Do not use scented or lotioned tissues or damage could result to the optics.

• Your spotting scope is waterproof: That is, it is designed to be used by the sportsperson, boater or casual user in an en virement in which exposure to water, such as rain, mist, splashing and so forth, might be a possibility. It is intended to be resistant to accidental exposure to water, but it is not designed for intentional submersion or extended use in water. If your spotting scope is intentionally immersed in water for any significant length of time, you risk  voiding the warranty in doing so.
  Also note that although your spotting scope may be used near a water environment, water on the lens will cause images to be distorted. Wipe off water from the entire device with a soft cloth when you leave the water environment.

WARRANTY & SERVICE
The regular guarantee period is 10 years and begins on the day of purchase.
You can consult the full guarantee terms and details of our services at www.bresser.de/warranty_terms.

| |
---|---|---
www.bresser.de/P4321500| www.bresser.de/P4322000| www.bresser.de/P4334500

Notes

Errors and technical changes reserved
Manual_4321500-4322000-4334500_Spotting-Scopes BRESSER_v012023a
Contact
Bresser GmbH
Gutenbergstraße 2
46414 Rhede · Germany
www.bresser.de
@BresserEurope

References

• art.no
• Bresser | Startseite | Expand Your Horizon mit BRESSER
• Bresser | BRESSER Pirsch 25-75x100 45° Spektiv | Expand Your Horizon
• Bresser | BRESSER Spektar 15-45x60 45° Spektiv | Expand Your Horizon

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>