Eibach F31-42-058-01-FA 2022+ Hyundai Santa Cruz Instruction Manual

: June 13, 2024
: Eibach

Table of Contents

Eibach F31-42-058-01-FA 2022+ Hyundai Santa Cruz
Product Information
Product Usage Instructions
Kit Contents
Installation
Bump Stop Modification
Contact Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Eibach F31-42-058-01-FA 2022+ Hyundai Santa Cruz

Eibach-F31-42-058-01-FA-2022+Hyundai-Santa-Cruz-
product

Product Information

The product mentioned in the user manual is a set of front and rear springs for the 2022+ Hyundai Santa Cruz. The kit contents include two front springs and two rear springs. The part numbers for the front and rear springs are F31-42-058-01-FA and F31-42-058-01-RA, respectively.

Product Usage Instructions

Before beginning the installation, read all the instructions provided.
Bump Stop Modification:
- Front Bump Stop: Reuse the original equipment (OE) bump stops.
- Rear Bump Stop: Reuse the OE bump stops.

For further assistance or technical support, you can contact Eibach at 1-800-507-2338 or visit their website at www.eibach.com.

Kit Contents

Front Spring
- F31-42-058-01-FA 2
Rear Spring
- F31-42-058-01-RA 2

Installation

Read all instructions before beginning the installation

Only qualified mechanics experienced in the installation and removal of suspension components should perform this installation.
The use of a hoist and screw jack is highly recommended and will substantially reduce installation time.
Never work on or under a vehicle unless it is properly supported by safety stands and the wheels are blocked.
Never use impact wrenches or impact guns to install or remove shock absorber piston components, shafts, and Piston rod nuts.
All Eibach springs should be installed with the Eibach logo right-side-up. All original stock spring isolators and dampers should be retained from the stock springs when installing Eibach PRO-LIFT KIT springs.
After Installation, inspect and adjust the following: Wheel Alignment; tire/wheel fender clearance when using aftermarket wheels or tires; brake line clearance and attachments; anti-lock-brake system sensors.
Tire Rotation: In order to increase the life of your tires, it is recommended to rotate your tires every 3,000 miles.
For MacPherson Strut-type front suspension, it is important to mark the orientation of the upper perch with respect to the lower perch before disassembly. This orientation must remain the same with the installation of the springs. Noise may result if this procedure is not performed correctly.