LIV and BO LED Toilet Light with Motion Sensor Instruction Manual

Assembly instructions
LED toilet light with motion sensor
Fits all standard toilets

Intended use:

• The product is intended for domestic/private use only and is not a toy
• The product is only suitable for use in toilets
• Position the product with the sensor facing the door
• Any use other than that described above is not permitted and can damage the LED toilet light.
• Improper use can also result in hazards and injuries.

Safety instructions!

Keep all safety instructions and manuals for future reference.

• Do not use old with new batteries, different brandsand chemicals

• Keep out of reach of children

• Do not swallow

• Do not throw into fire
  Risk of death and injury for toddlers and children

• Children must not play with LED toilet lights and cleaning must not be carried out by children without supervision.

• Do not allow children to play with the packaging material and parts of the packaging (risk of suffocation).

• Keep batteries out of the reach of children. Risk of death and accidents

• Do not charge, damage or open the batteries.

• Do not swallow the batteries. If batteries are swallowed, seek medical assistance immediately.

• Do not throw the batteries into fire, never expose them to excessive heat (e.g. sun, fire). There is a risk of explosion.

• If batteries have leaked, remove them from the battery compartment using a cloth and dispose of them correctly. Avoid skin and eye contact with battery acid. In the event of eye contact with battery acid, rinse the eyes with plenty of water and consult a doctor immediately. If battery acid comes into contact with skin, wash the area with plenty of water and soap.

• Caution risk of glare: Do not look directly into the LED!
  CAUTION

• Do not convert the LED light yourself!

• The light source of this light cannot be replaced; when the light source has reached its end of life, the entire light must be replaced.

• The polarity of the batteries must match that of the product.

Included in delivery:

• 1x LED toilet light
• 3x 1.5V AAA (LR03) alkaline batteries

Parts:
A = LED light
B = Sensor
C = LED toilet light housing
D = Selection knob
E = Flexible holder
F = 1.5V AAA (LR03) alkaline batteries
G = Battery compartment

Commissioning / installation instructions:

1. To operate the LED toilet light, loosen the screw using a PH1 Phillips screwdriver (not included) on the back of the LED toilet light housing, lift the cover of the battery compartment and place the batteries (F) in the battery  compartment (G).
   Make sure that the polarity (+ and -) is correct.
   Then screw the battery compartment lid back on. Make sure that the cover is flush.
   Note: If the LED light is no longer lit, you should replace the batteries.
   Please proceed as describedin 1 .

2. Note: If the LED light is no longer lit, you should replace the batteries.
   Please proceed as describedin 1 .

3. The flexible holder (E) must be bent before hanging the LED toilet light in the toilet. When the LED toilet light housing (C) rests against the edge of the toilet, bend the flexible holder (E) towards the toilet so that the flexible holder rests on it. To hang it in its final position, bend the free end of the flexible holder down so that the holder wraps around the edge of the toilet.

4. The LED (A) lights up for approx. 2 minutes after detecting a motion in a darkened room. It lights up in 8 different, repeating colours and switches off automatically after approximately 2 minutes after the first motion detection.
   Note: The sensor only works in the dark.

5. There are 2 options for the continuous light function: briefly press and hold the selector (D) at the desired colour after motion detection in a darkened room.
   The light switches off again automatically after approx. 2 minutes without motion detection.
   Or press the selector if you need a light source.
   The continuous light then illuminates even in bright surroundings without motion. The light can only be switched off by pressing the button again.
   Alternatively, it switches off automatically when the surrounding area gets dark.

Cleaning:

Easy to clean using a damp cloth.
Clean the LED light (A) carefully and do not pull on it. Do not immerse the toilet light in water or hold it under running water.

Technical specifications:

• Input voltage: 4.5 V / Power: 100 mW
• Power supply: 3x 1.5V AAA (LR03) alkaline
• Enclosure rating: IP44 (splash-proof)

Explanation of symbols:

| Keep out of reach of children
---|---
| Do not throw into a fire or expose to excessive heat
| Do not insert batteries the wrong way round
| Do not damage the batteries
| Do not open the batteries
| Do not use different brands and chemicals
| Do not use old with new batteries
| Do not charge the batteries
| Protect the batteries from moisture
| Avoid short circuit
| The polarity of the batteries must match that of the product
| Products marked with this symbol comply  with all applicable Community regulations of the  European Economic Area.
The EU declaration of conformity can be requested from the address provided.
| The toilet light complies with protection class III.

Batteries must not be disposed of with household waste
As a consumer, you are legally obliged to dispose of all batteries and accumulators, regardless of whether or not they contain harmful substances, at a collection point in your municipality/ district or at retailers, so that they can be  disposed of in an environmentally friendly manner.
Old appliances must not be disposed of with household waste.
Do not throw your product in the household waste once it has reached the end of its useful life. Dispose of it correctly in the interest of environmental protection.
You can find information on collection points and their opening hours from your responsible authority.

CUSTOMER SERVICE

Conmetall Meister GmbH
Oberkamper Str. 39
42349 Wuppertal
GERMANY
0202 24750 430 / 431 / 432
(Call costs according to the landline tariff of your telephone provider
+800 34 99 67 53
from abroad
meister-service@conmetallmeister.de

WC-LED Licht

Conmetall Meister GmbH
Oberkamper Str. 39
D-42349 Wuppertal
WU6823491-8
3x 1,5V AAA (LR 03)/0, 1W
Manufactured: 06/2023
IAN 426123_2301
WEEE:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>