carbatec CT-CROCH-CH Hook Kit Instructions
- June 12, 2024
- carbatec
Table of Contents
carbatec CT-CROCH-CH Hook Kit
REQUIRED TOOLS AND ACCESSORIES
- 7 mm pen mandrel (MAND-92)
- 9.5(3/8”) mm Drill Bit (BPD-38-PRC)
- Barrel Trimmer (PKTRIMKIT)
- 2 pcs Bushings Set (BUSH-CROCH)
- 2 part epoxy glue or CA super glue (cyanoacrylate)
- Wood or acrylic blank, minimum size 3/4″ square
- Sanding and finishing supplies
The barrels are made out of turned wood or acrylic blanks.
PREPARING THE BLANK
- Cut a 3/4” or larger blank, to the length of the brass tubes (add 1/16” for squaring off).
- Drill an 9.5mm (3/8″) hole through the centre of the blank.
- Spread glue over the tube.
- Insert the tubes into the blank with a twisting motion to spread the glue evenly inside.
- Centre the tubes lengthwise inside the blank.
- When the glue is dry, trim the ends of the blank flush to the tube.
TURNING THE BLANK
- Place the bushings and blank onto the mandrel according to figure 1.
- Thread on the knurled nut and hand tighten on the mandrel to hold components in place.
- Slide the tailstock to the mandrel shaft and lock in place (do not overtighten or it could damage or bend the mandrel).
- Turn the handle ends down, flush with the bushings using turning chisels, finishing by gradually increasing grades of sandpaper.
- Finish the blank by applying polish or other finish.
CROCHET HOOK ASSEMBLY
ASSEMBLY
-
Line up the components according to Figure 2.
-
Press the cap and clip assembly to one end of the tube.
-
Screw the crochet hook into the crochet hook holder.
There are 8 sizes hooks options. -
Slide the crochet hook holder in and out with both ends to assure a secure fit.
-
When not in use, reverse the hook assembly to safely store the hook.
CUSTOMERS SUPPORT
Carbatec Pty Ltd
128 Ingleston Road, Wakerley,
Queensland, Australia
1800 658 111 – CARBATEC.COM.AU
Carbatec New Zealand Ltd
110 Harris Rd, East Tamaki,
Auckland 2013, New Zealand
0800 444 329 – CARBATEC.CO.NZ
References
Read User Manual Online (PDF format)
Loading......