DRIVEN WH1332 R-C Recycling Truck Instruction Manual
- June 12, 2024
- DRIVEN
Table of Contents
MICRO SERIES
R/C RECYCLING TRUCK
Instruction Manual
WH1332 R-C Recycling Truck
https://qrcodes.pro/PzFTiq
3+ years
TO START PLAYING:
- Make sure the ON/OFF switch on the vehicle is in the ON position (Fig. 1).
- Press on the vehicle’s roof, as indicated in (Fig. 2), then press any button on the remote, as indicated in (Fig. 3).
TROUBLESHOOTING:
NOTE: In the event that the controller and/or vehicle are not responsive,
press the RESET BUTTON on the back of the remote (Fig. 4) to continue playing.
If the controller and/or vehicle still fail to connect, switch the vehicle OFF
and back ON again (Fig. 1). Continue with step 2.
If the connection issue persists, replace the batteries in the vehicle (Fig.
- and in the remote (Fig. 4) with new alkaline batteries. Continue with step
1 & 2.
NOTE: The vehicle will automatically go into sleep mode after 30 minutes of inactivity to save power. Wake up by pressing on the vehicle’s roof, as indicated in (Fig. 2).
|
---|---
STEERING ALIGNMENT ADJUSTMENT
If the vehicle does not drive in a straight line, adjust the alignment using
the alignment lever. If the vehicle drifts to the left, turn the lever towards
the “R”. If the vehicle drifts to the right, turn the lever towards the “L”.
Please remove all packaging materials before giving to children.
Please retain this information for future reference.
User Guide:
- Do not use near seawater or in dirty and dusty environments.
- Do not use in the rain or immediately after rainfall.
- If the vehicle gets wet, open the battery compartment immediately, remove batteries, and turn the vehicle upside down to dry.
- Always clean and dry the vehicle and remote after using outdoors to avoid damage.
- The remote’s control distance may be reduced when using indoors.
- The vehicle’s remote control may not work after long storage.
Follow the steps below to re-start:
A) Always replace the batteries in the vehicle with 3 new AAA alkaline
batteries (Fig. 1).
B) Follow steps 1 and 2 on the first page to start playing.
C) If the vehicle does not work, put 2 new AAA alkaline batteries in the
remote (Fig. 4).
D) Follow steps 1 and 2 on the first page to start playing.
BATTERY ADVICE
Requires 3 x AAA(1.5V) batteries for the truck (included) Requires 2 x
AAA(1.5V) batteries for the remote control (not included) Non-rechargeable
batteries are not to be recharged. Rechargeable batteries are to be removed
from the toy before being charged. Rechargeable batteries are only to be
charged under adult supervision. Different types of batteries or new and used
batteries are not to be mixed. Only batteries of the same or equivalent type
as recommended are to be used. Batteries are to be inserted with the correct
polarity. Exhausted batteries are to be removed from the toy.The supply
terminals are not to be short-circuited.
ATTENTION: When the module’s functions lose performance, follow
instructions carefully to install new batteries.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Troubleshooting
Frequency bands: 2405MHz-2475MHz
Maximum radio-frequency power: 5dbm
Use alkaline batteries for longer play time.
WARNING: This toy produces flashes that may trigger epilepsy in
sensitised individuals. WARNING!: SMALL PARTS – CHOKING HAZARD. Not
suitable for children under 3 years.
WH1332/WH1332Z
WARNING: CHOKING HAZARD—Small parts. Not for children under 3 years.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>