CRUX SWRSU-38A Radio Replacement with Steering Wheel Control Retention Instruction Manual
- June 4, 2024
- CRUX
Table of Contents
SWRSU-38A
Radio Replacement with Steering Wheel Control Retention for
Select SUBARU Vehicles 2007 – 2009
PRODUCT FEATURES:
- Retains factory features in select Subaru vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- EIA color coded wiring for easy installation.
PARTS INCLUDED:
INSTALLATION DIAGRAM:
DIP SWITCH SETTINGS:
SUBARU STEERING WHEEL CONTROL DIP SWITCH SETTING:
| DIP:| 5| 6| 7| 8
---|---|---|---|---|---
Panasonic made Radio| ON| OFF| OFF| OFF| ON
Clarion made Radio*| OFF| ON| ON| OFF| ON
Clarion made Radio**| ON| OFF| OFF| ON| OFF
Fujitsu Ten made Radio| OFF| ON| ON| OFF| ON
AFTERMARKET RADIO DIP SWITCH SETTINGS:
NOTE: For Atoto, Blaupunkt, Dual, Farenheit, Power Acoustik, Soundstream, and most off-brand radios, check the aftermarket radio’s manual to see if the SWC buttons need to be programmed.
3.5MM SWC CABLE
Plug in the 3.5MM to 4-Pin SWC cable to the SWC module.
NOTE: Insulate the Blue/Yellow and Green wires if not being used.
For aftermarket radios that have wires for SWC connections, cut off the 3.5mm
plug on the Crux SWC Cable (option B) and connect the SWC wires as follows:
Note that there are some radios that only have SWC1 and SWC2, in this case
“shield” does not need to be connected.
INSTALLATION INSTRUCTIONS:
1. Carefully remove the gear shifter
trim ring.| 2. Use a plastic pry bar and carefully lift
and remove the gear shifter trim bezel.| 3. Unplug the cigarette lighter
connection.
4. Remove the screws holding the left
and right side trims.| 5. Remove the left and right side trims.| 6. Remove
the screws holding the
radio.
7. Unplug the hazard light connector.| 8. Unplug the connectors behind the
radio.| 9. Note that the SWC connection is
made on the 8-pin connector.
8. Use the necessary dash kit (not included) to complete the installation.
Connect the aftermarket radio wires to the SWRSU-38A T-harness.
9. Plug in the SWRSU-38A 8-pin SWC connector to the factory mate.
10. Confirm the DIP Switch settings and test the steering wheel controls for
functionality.
11. Test the radio for other functionality before installing the new radio
into the dash. Reverse the radio removal process.
VEHICLE APPLICATIONS:
SUBARU
2007-2009| Legacy (without Automatic Climate Controls)
2007-2009| Outback (without Automatic Climate Controls)
http://www.cruxinterfacing.com
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: 818-609-9299 • fax:
818-996-8188 •
www.cruxinterfacing.com
rev.031220
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>