EDIFIER W210BT Wireless Neckband Headphones Instruction Manual

: June 13, 2024
: Edifier

Table of Contents

EDIFIER W210BT Wireless Neckband Headphones
Product Information
Product Usage Instructions
Power ON/OFF

EDIFIER W210BT Wireless Neckband Headphones

EDIFIER-W210BT-Wireless-Neckband-Headphones-PRODUCT

Product Information

Product Name: W210BT Wireless Neckband Headphones

Manufacturer: Edifier International Limited

Model Number: EDF200104

Website: www.edifier.com

Product Usage Instructions

1. Power ON/OFF

To power on the headphones, press and hold the power button for 3 seconds.

To power off the headphones, press and hold the power button for 3 seconds.

Pairing

First Pairing:

Make sure the headphones are powered off.
Press and hold the power button for 5 seconds. The green and red LEDs will blink rapidly.
Select “EDIFIER W210BT” in the Bluetooth settings of your device to connect.

Subsequent Pairing:
After the first pairing, the headphones will automatically connect to the last device used.

3. Reset

Make sure the headphones are powered on and disconnected from all devices.
Press and hold the “+” and “-” buttons simultaneously for 5 seconds.
The status light will blink green until the reset is completed.
Once the headphones are reset, they will enter pairing mode automatically.
Controls

The headphones have the following controls:

Power Button: Press and hold for 3 seconds to power on/off.
Volume Buttons: Press to adjust the volume.
Playback Control Buttons: Press to control playback (e.g., play, pause, skip).

Note: The images shown in the manual are for illustrative purposes only and may differ from the actual product. For more information, please visit the Edifier website.

Power ON/OFF

Press and hold the power button for 3s.

Pairing

When they’re power off, press and hold the power button for 5s. Green and red LED will blink rapidly.
Select “EDIFIER W210BT” in your device setting to connect.

1st Pairing

Once the headphones are power on, they will enter Bluetooth pairing automatically. Green and red LED will blink rapidly.
Select “EDIFIER W210BT” in your device setting to connect.

Note:
For subsequent use, the headphones will auto-connect to device used last time.

Reset

The headphones are power on and disconnected from all devices.
Press and hold the ” ” and “v” at the same time for 5s.
The status light blinks green until reset is completed.
Once the headphones are reset, they enter pairing mode automatically.

Controls

EDIFIER-W210BT-Wireless-Neckband-Headphones-
FIG-43

Note:

Press and hold
Images are for illustrative purposes only and may differ from the actual product.

For more information, please visit our website:

www.edifier.com
@Edifierglobal
@Edifier_Global
@Edifier_Global

Model: EDF200104
Edifier International Limited
P.O. Box 6264 General Post Office Hong Kong
www.edifier.com
2023 Edifier International Limited. All rights reserved.
Printed in China

NOTICE:
For the need of technical improvement and system upgrade, information contained herein may be subject to change from time to time without prior notice. Products of EDIFIER will be customized for different applications. Pictures and illustrations shown on this manual may be slightlydifferent from actual product. If any difference is found, the actual product prevails.