MeTra 99-3105 Dash Kit Instruction Manual
- June 13, 2024
- Metra
Table of Contents
99-3105
INSTALLATION
INSTRUCTIONS
KIT FEATURES
- DIN head unit provisions
- Pocket (holds 2 jewel cases)
KIT COMPONENTS
TOOLS REQUIRED
ALL VEHICLES
Disconnect the negative battery terminal to prevent an accidental short
circuit. Remove (2) pop-clips from the sides of the radio trim bezel. Unclip
the radio trim bezel, disconnect the switch wiring and remove the bezel.
Remove (2) 7mm hex-head screws securing the top of the factory head unit and
disconnect the wiring.
Mount the Radio
Housing to the sub-dash with (2) 7mm hex-head screws previously removed in
step #1. Reach through the Radio Housing and mount the lower Housing tabs to
the sub-dash with (2) Captive Studs and (2) Pal Nuts supplied.
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adaptor and making connections as shown. (Isolate and
individually tape off the ends of any unused wires to prevent electrical short
circuit).
Slide the DIN cage into the kit and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. Re-connect the battery terminal and test the unit for proper operation.
rev. 290601
**** 1-800-221-0932
www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>