BERTSCHAT ELITE Heated Socks Instructions

**BERTSCHAT ELITE Heated Socks Instructions

**

BEFORE FIRST USE

The batteries are not fully charged and must therefore be charged before first use for 8 hours minimum, regardless of the colour of the indicator LED. To get started insert the charger plugs in the charging ports of the batteries. Fully charging the batteries activates them, thus allowing the full capacity to be accessed. The LED on the charger lights up in red during charging and turns green once the battery is fully charged. Finally, remove the batteries from the charger, place them in the appropriate pockets in the socks and connect them to the plugs.

SWITCHING ON THE HEATING

The socks are switched on by pressing the button on the side. After that, pressing the button again changes the temperature settings. When 3 LEDs are visible the socks are heating at maximum power while 2 or 1 LED indicates heating at the lower levels, allowing for longer battery life. Pressing once more at the lowest level turns the heating function off.
A sensor in the shirt ensures that the temperature always remains at the set value.

TEMPERATURE SETTINGS

The temperature can be set by pressing the silicon button. When in use the LEDs on the button light up according to which setting is active:

Colour LED| Heating position|
---|---|---
3 LEDS| Highest position
2 LEDS| Medium position
1 LEDS| Lowest position
LED does not light up| Heating function switched of

OPERATING TIME

The heating duration of the socks depends on several factors: primarily the ambient temperature and secondly the level of insulation added by socks worn over the socks. Lastly, a high setting will obviously deplete the batteries faster than any of the lower settings. It should also be noted that the batteries only reach their full charging capacity after a few charging cycles.
Consider ordering an additional battery pack for longer use time.

SWITCHING OFF

The heating function is switched off by pressing the ON/OFF buttons until the LEDs no longer light up or alternatively by simply disconnecting the batteries.
After use of the socks, always disconnect the batteries and keep them stored in their intended pockets. Store the socks and the batteries in a dry and clean environment at room temperature.

STORAGE AND BATTERY MAINTENANCE

If you don’t intend on using the socks for a longer period, we recommended storing the batteries charged between 50 and 75%. To do this first fully charge the batteries, then switch on only one side of the socks at the medium setting for 20 – 30 minutes. Finally make sure to disconnect the batterie from the socks. We urge to repeat these steps every 2 months to ensure that the batteries remain in good condition.

ADDITIONAL INSTRUCTIONS

• Always switch off the socks after use.
• Disconnect the batteries when not in use.
• Store socks, battery, and adapter in a cool and dry location.
• The batteries should only be charged with the original charger.
• Always remove the battery from the socks before charging them.
• Never pull too hard on the socks as the heating elements could get damaged.
• Keep the shirt away from sharp or pointed objects.

CONNECTING THE REMOTE CONTROL (OPTIONAL)

The version with remote control should be paired before first use. If the connexion has however been lost it will first have to be repaired before the socks will respond to the remote again. Perform the following steps for connecting the remote control:

1. Switch on both socks by pressing the ON button.
2. Press the ON button of the sock once more and hold it down for 5 seconds until the LED flashes.
3. Press position L, M or H on the remote control to make the connection.
4. The sock is now connected. Repeat this process for the other sock as well.

WASHING INSTRUCTIONS

• Only wash by hand! Use a soft washing agent and handle the sock with care.
• Only allow the socks to dry naturally and do not place them on the heating or any other heat source.
• If the socks are damp, allow them to dry fully before charging.
• Do not dry clean the socks.
• Do not iron the socks.

TROUBLESHOOTING

If you notice that the socks do not get warm, you can do the following test:

• Charge both batteries at the same time and interchange batteries. This determines whether the battery or the mitten is no longer functioning properly.
• Does the LED on the charging cable not light up? The plug or charging cable is defective and does not receive any power.
• Insert both connectors in the socks in the ports of the batteries. Now place the batteries in the pockets  inside the socks and then close the zip.
• The heating is switched on when pressing the black silicon ON/OFF button on the top of the socks. The LED on the silicon button lights up to confirm that the heating function is switched on.
• When the LED is lit up the socks are heating: you should be able to feel the generated heat within 1 minute at the fingers and at the top of the socks.

WARNINGS

• The socks are not suitable for use by minors.
• Do not make any changes to the socks and/or battery.
• In case of damage to battery or charger, stop using the product.
• Leave the protective plastic around the battery.
• If the battery swells up, immediately stop using it and contact the manufacturer.
• Do not drill through the battery packs or make holes in the battery in any other way.
• Make sure the heating elements do not overlap for a longer period, this could lead to a situation where the temperature is too hot.
• This product is only intended to be used by people and should not be used on animals.
• The socks can become very warm. If you have a reduced sensitivity to heat or cold, we recommend consulting a doctor first.
• In case of a higher ambient temperature, the sensation of heat will be stronger. In that case, set the socks to a lower position that does feel comfortable.
• Incorrect use of the batteries may result in a possible explosion hazard.
• Avoid direct skin contact with the heating elements as this could lead to skin burns. If you notice a hole in the fabric or a visible heating wire, stop using the socks and contact your supplier immediately.

IMPORTANT

• Please carefully read the user manual before use.
• This product is not suitable for children
• This product is not suitable for persons with reduced physical, sensory or mental capabilities or persons who are under supervision and/or do not understand hazards. All above-mentioned persons should not be allowed to use this product.
• Children are never allowed to play with this product.
• Cleaning and care should not be performed by children who are not supervised.
• The heated products and the battery packs should be regularly checked for signs of wear or damage. If such signs are visible, the product has been used incorrectly, or if the product does not function, we urge the customer to stop using it and to send it back.
• Elderly people or persons with reduced sensitivity of the skin are advised to not use the product.
• The product may not be used for warming animals.
• If you have difficulty sensing heat or cold (disabled persons, etc.), please consult your doctor before using the product.
• Regularly check your body for any discolourations of the skin. Heating at too high intensity for long periods of time can cause burns.
• The heated products may only be used in combination with the original batteries.
• Always use the original supplied charger for charging. It is only intended for indoor use and should not be exposed to humidity.
• Never try to open or repair a battery yourself.
• In case of questions or any failures, always immediately contact the supplier.
• Do not make any changes to the product and do not use it for any other purposes.
• Repairs to the battery packs and other components should only be performed by the manufacturer.
• Hand in used battery packs at a collection point for electronic waste.
• Explosion hazard: do not store battery packs near a heat source and do not throw them in open fire.
• Never drill through the battery packs. Explosion hazard.
• The product is not intended for use in hospitals.
• The technology used in the heated products is compliant with all relevant legislation and regulations. Whether the product can be used in the vicinity of other sensitive electronic products (such as pacemakers, etc.) must be confirmed by the manufacturers of these electronic products.
• Make sure that no other objects are placed on top of the product during storage, as it could bend the heating filaments.
• If an environment is entered that has a considerably higher temperature, the heating must be switched off to prevent overheating of the body.
• Never use heated products in combination with other heated products, too much heat can lead to overheating.

DISPOSING OF THE BATTERIES

As we also supply batteries with our product, we are obliged according to legislation that applies to batteries to point out the following to you:

Batteries may not be disposed of as household waste. The consumer is legally obliged to return batteries separately after use. Old batteries could contain harmful substances that could damage your health or the environment if not properly stored and disposed of. However, batteries also contain important raw materials such as iron, zinc, manganese, or nickel and can be reused. After use, you can return the batteries to us or hand them in for free at a location near you (e.g., at a shop or a municipal collection point). The crossed waste container symbol indicates that batteries should never be thrown out with your household waste.

If you have any questions or if anything is unclear, please contact your supplier.

References

• BERTSCHAT®️

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>