BERTSCHAT Hoodie Pro Dual Heating Men Zwart Instruction Manual
- June 13, 2024
- BERTSCHAT
Table of Contents
BERTSCHAT Hoodie Pro Dual Heating Men Zwart
Product Information
- Product Name: Dual Heating Hooded Vest
- Model: Not specified
- Languages: English, German (DE), Italian (IT), Dutch (NL)
General Operation
The button lights up in different colors to indicate the heating position:
GENERAL OPERATION
The BERTSCHAT® hooded vest heats the body by means of heating elements, supplied in electricity by two USB power banks. The vest can provide warmth at 3 different heat settings which can be adjusted by pressing the buttons on the chest. The front and back can be configured separately from each other allowing to always find the ideal temperature. The power banks are stored in the pockets on both sides of the vest where the connecting plugs are equally located.
SWITCHING ON THE HEATING
Connect the vest to the powerbank and switch it on. The buttons located on the chest should flash once indicating a successful connection after which it the temperature can be switched by pressing them again. The front side and back side heating need to be activated independently from one another. Active LED lights indicate that the vest is heating. After this, the heating position can be adjusted by clicking on the button. The vest has three heating posi-tions. The vest starts at the warmest position when switched on.
The button lights up in the colour that corresponds with the set heating position:
Color LED | Heating Position |
---|---|
Red | Highest position |
Orange | Medium position |
White | Lowest position |
LED does not light up | Heating function switched off |
OPERATING TIME
The heating duration of the vest depends on several factors: primarily the
ambient temperature and secondly the level of insulation worn under and over
the vest. Lastly, a high setting will obviously deplete the batteries faster
than any of the lower settings. It should also be noted that the batteries
only reach their full charging capacity after a few charging cycles.
Consider ordering an additional battery pack for longer use time.
SWITCHING OFF
The heating function is switched off by pressing the ON/OFF buttons until the
LEDs no longer light up or alternatively by simply disconnecting the
batteries.
After use of the vest, always disconnect the batteries and keep them stored in
their intended pockets. Store the vest and the batteries in a dry and clean
environment at room temperature.
ENERGY CONSUMPTION & POWER BANK
The vest works on any 5V USB power source, such as a telephone charger or
laptop USB connection. For mobile use a power bank will be necessary. Although
any power bank with a 5V USB connection can be used in combination with the
vest, BERTSCHAT® recommends using the separately available BERTSCHAT® power
bank designed for this use.
Most USB power banks are equipped with a 1A or 2.1A connection. Though the
vest will work on a 1A connection it will be able to generate more heat when
connected to a 2.1A connection. However, when using the 2.1A connection, the
power bank will deplete more quickly because more power is used.
It goes without saying that the more capacity the utilised power bank has, the
longer it will be able to heat. Some power banks must be switched on manually
before they provide power. Both the power bank and the vest will then have to
be switched on before the vest can become warm.
- Switching on : press the button once. By means of the indicator LEDS, you can read how much power remains.
- Switching off : press the button once more.
ADDITIONAL INSTRUCTIONS
- Always switch off the vest after use.
- Disconnect the batteries when not in use.
- Store vest, batteries, and adapter in a cool and dry location.
- The vest should only be charged with the original charger.
- Always remove the battery from the vest before charging them.
- Never pull too hard on the vest as the heating elements could get damaged.
- Keep the vest away from sharp or pointed objects.
WASHING INSTRUCTIONS
There are heating elements in the vest, which are sturdy, but can get damaged when handled roughly. Handle the vest with care to prevent damage. Carefully place the power bank in the pocket. Do not allow the power cable of the vest to kink. Make sure the USB plug and cable are not subjected to excessive force.
- Only wash by hand! Use a soft washing agent and handle the vest with care.
- Do not put the vest in the tumble dryer, only allow the vest to dry naturally and do not place it on the heating or any other heat source.
- If the vest is damp, allow it to dry fully before charging.
- Do not dry clean the vest.
- Do not iron the vest.
TROUBLESHOOTING
If you notice that the vest doesn’t get warm, you can execute the following test:
- Is the power bank fully charged?
- Check if the 4 white LED lights activate when pressing the button.
- Is the power bank connected correctly?
- Check that the power bank is properly connected to the plug.
- Is the plug of the vest free from contaminations?
- Dirt in the plug could block the connection.
- Test if the vest is working as follows: connect the vest to a fixed USB power source, such as a smartphone charger. If the vest is working, it is possible that the power bank is defective.
- Does the power bank not have sufficient power?
Try a different/stronger power bank with a minimum output of 2.1A.
FURTHER INSTRUCTIONS
- Always switch off the vest after use.
- Remove the plug from the power bank if you are not using it.
- Store vest and power bank in a cool and dry location.
- Always remove the power bank from the vest before charging it.
- Never pull the vest too hard, as the heating elements could get damaged otherwise.
- Keep the vest away from sharp or pointed objects.
WARNINGS
- The vest is not suitable for use by minors.
- Do not make any changes to the vest.
- In case of damage to power bank or charger, stop using the product.
- When the power bank swells up, immediately stop using it and contact the manufacturer.
- Do not drill through the power bank or make holes in the power bank in any other way.
- Make sure the heating elements do not overlap for a longer period of time, this could lead to a situation where the temperature is too hot.
- This product is only intended to be used by people and should not be used on animals.
- The vest can become very warm. If you have a reduced sensitivity to heat or cold, we recommend consulting a doctor first.
- In case of a higher ambient temperature, the sensation of heat will be stronger. In that case, set the vest to a lower position that does feel comfortable.
- In case of incorrect use of the power bank, there is a possible explosion hazard.
- Avoid direct skin contact with the heating elements at all times, this could lead to burns in case of long-term use. If you notice a hole in the fabric and the heating wire becomes visible, stop using the vest.
IMPORTANT
- Please carefully read the user instructions.
- This product is not suitable for children
- This product is not suitable for persons with reduced physical, sensory or mental capabilities or persons who are under supervision and/or do not understand the hazards. These above-mentioned persons should not be allowed to use this product.
- Children are never allowed to play with this product.
- Cleaning and care should not be performed by children who are not supervised.
- The heated products as well as the battery packs should be regularly checked for signs of wear or damage. If such signs are visible, the product has been used incorrectly or the product does not function, it should be sent back to the supplier before it is used again.
- Elderly people or persons with reduced sensitivity of the skin are advised to not use the product.
- The product may not be used for warming animals.
- If you have difficulty sensing heat or cold (disabled persons, etc.), please consult your doctor before using the product.
- Regularly check your body for red discolourations of the skin. A heating power that is too high for a longer period of time could cause burns.
- The heated accompanying products may only be used in combination with the original batteries.
- Always use the original supplied charger for charging. It is only intended for indoor use and should not be exposed to humidity.
- Never try to open or repair a battery yourself.
- In case of questions or any failures, always immediately contact the supplier.
- If you establish damage to the charger, charging cable or other parts of the product, the product should no longer be used.
- Do not make any changes to the product and do not use it for any other purposes.
- Have repairs to the battery packs and other components only performed by the manufacturer.
- When the battery packs are no longer being used, hand them in at a collection point for electronic waste.
- Do not store battery packs near a heat source and do not throw them in open fire. Explosion hazard.
- Never drill through the battery packs. Explosion hazard.
- The product is not intended for use in hospitals.
- The technology used complies with all relevant legislation and regulations. Whether the product can be used in the vicinity of other sensitive electronic products (such as pacemakers, etc.) must be checked at the manufactur ers of these electronic products.
- Make sure that no other objects are placed on top of the product during storage, as it could bend as a result.
- If an environment is entered that has a considerably higher temperature, the heating must be switched off, as overheating could occur otherwise.
- Never use heated products in combination with other heated products, heat on heat could lead to overheating.
DISPOSING OF THE BATTERIES
As we also supply batteries with our product, we are obliged according to
legislation that applies to batteries to point out the following to you:
Batteries may not be disposed of as household waste. The consumer is legally
obliged to return batteries separately after use. Old batteries could contain
harmful substances that could damage your health or the environment if not
properly stored and disposed of. However, batteries also contain important raw
materials such as iron, zinc, manga-nese, or nickel and can be reused. After
use, you can return the batteries to us or hand them in for free at a location
near you (e.g., at a shop or a municipal collection point). The crossed waste
container symbol indicates that batteries should never be thrown out with your
household waste.
If you have any questions or if anything is unclear, please contact your
supplier.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>