bkvibro AC-1405 Velocity Sensor Instructions
- June 4, 2024
- bkvibro
Table of Contents
bkvibro AC-1405 Velocity Sensor Instructions
Product Description
- ferule without isolation
- Cable screen flush cutted, additional wire tinned
L = Cable length
NOTE:
This manual is a part of the product. Read the manual carefully before using
the product and keep it safe and easily accessible for future use.
Application
The four-core connection cable AC-1405 is suitable for the connection of sensors and transmitters with 4-pole M12-plug to a machine monitoring system.
Technical data
- Plug design: M12, 4-pole, female, straight plug
- Cable length L: 5,0 m; 10,0 m
- Number of conductors: 4
- Conductor cross section: 4 x 0,34 mm²
- Conductor resistance: ≤ 5mΩ
- Shield connected to union nut
- Bending radius: min. 26 mm statisch min. 62 mm dynamisch
- Outer jacket: PUR, black
- Outer diameter: 5,1 mm
- Operating temperature range: -30 °C .. +90 °C
- Storage temperature range: -40 °C .. +90 °C
- Mating cycles min.: 100
IP-protection acc. to EN 60529: IP65, IP67, IP68
Connection
NOTE:
Check for function and damage to the cable prior to each commissioning.
Replace damaged cables immediately.
Install the connecting cable by putting the correctly aligned plug onto the
sensor. Tighten the union nut. Press the plug further towards the sensor.
Repeat this process as often as necessary until the plug cannot be pressed any
further into the socket. Then tighten the union nut. For deinstallation,
proceed in the reverse order.
Fig 1) Pin configuration of the M12-cable connector
PIN Configuration
Pin|
Wire colour
1| Brown
2| White
3| Blue
4| black
Order code
Support
Brüel & Kjær Vibro GmbH
Leydheckerstrasse 10
D-64293 Darmstadt
Phone: +49 6151 428-1400
Fax : +49 6151 428-1401
E-Mail : [email protected]
AC-1405 / C108242001/ V01
© Brüel & Kjær Vibro