baby lock ESG-TP Free Motion Transparent Foot Instructions
- June 12, 2024
- Baby Lock
Table of Contents
baby lock ESG-TP Free Motion Transparent Foot
Product Information
The Free Motion Transparent Foot is a sewing accessory designed for use with Baby Lock sewing machines. It is used for various techniques such as stippling, meandering, and thread painting. This foot allows for greater visibility while sewing, making it easier to create intricate designs.
The Free Motion Transparent Foot can be used with a variety of threads, including The Finishing TouchTM, SulkyTM, variegated, and metallic threads. The choice of thread will determine the type of needle to be used. For metallic or heavier threads, it is recommended to use a Metallica needle, which has a larger, longer eye to prevent fraying and shredding of the thread. When using the Baby Lock Esante (ESE, ESE2) sewing machine for free motion work, it is important to set it up correctly for optimal results. Lower the feed dog and lengthen the stitch to the longest setting. Weaken the tension to the weakest setting and increase the speed to the fastest speed. This adjustment is necessary because the Esante’s (ESE, ESE2) tension rollers are pre-set for each stitch, and these changes ensure that the appropriate amount of thread is delivered for the selected stitch.
For further assistance or inquiries, you can contact Baby Lock customer support at 800-422-2952 or visit their website at www.babylock.com.
Instructions
- The Free Motion Foot can be used for stippling, meandering and thread painting.
Stippling
Stippling is done with the needle in the center straight stitch position and the feed dogs lowered. To start, bring up the bobbin thread to the top of the fabric, sew a few stitches, and trim your thread. Run your Baby Lock machine at the fastest speed and move your fabric in a slow, fluid motion. Stippling simply means you do not cross over any of the stitches.
Meandering
- Meandering is done following the directions above, except the stitches are crossed.
Thread Painting
- Thread Painting is a fun technique and was an early form of computerized machine embroidery. To start, drop the feed dogs and fill in the design you are creating with either a straight or a zigzag stitch.
Threads and needles to use
A variety of threads may be used, such as The Finishing Touch™, Sulky™, variegated and metallics. The thread you choose will determine the needle you need. When using metallic or heavier threads, be sure, to use a Metallica needle. This needle has a larger, longer eye than the typical needle which prevents the thread from fraying and shredding.
Esante (ESE, ESE2) Set Up Instructions
Setting up your Baby Lock Esante correctly for free motion work is essential for good results. Lower the feed dog and lengthen your stitch to the longest setting. Weaken your tension to the weakest setting and increase your speed to the fastest speed. Because the Esante’s (ESE, ESE2) tension rollers are pre- set for each stitch, this adjustment is needed to deliver an appropriate amount of thread for the selected stitch.