ams AS5170 Socket Board User Manual
- October 30, 2023
- ams
Table of Contents
ams AS5170 Socket Board User Manual
Introduction
The AS5170-SO_EK_SB socket board is used for quick programming of the AS5170A and AS5170B magnetic rotary position sensors without soldering due to its ZIF socket. This board can be used in combination with the AS5xxx-EK-USB-PB UART Programming Board and the provided LabVIEW evaluation software.
Figure 1: Kit content
Pos: 1
Item :AS5170-SOEK
Comment :SB Socket board
Board description
The PCB offers direct connecting option to the AS5xxx-EK-USB-PB UART Programmer with the 4-pin single-row connector on the left side. A ZIF Open- Top-Socket for SOIC8 packages is mounted in the middle. Pin 1 of the IC is indicated by a small white dot on the PCB.
All passive components needed for proper operation are included on bottom side the PCB.
Figure 2: AS5170 socket boar
AS5170-SO_EK_SB Hardware
AS5170-SO_EK_SB schematics
Figure 3: AS5170-SO_EK_SB schematic
AS5170-SO_EK_SB PCB layout
Figure 4 : AS5170-SO_EK_SB PCB layout
Ordering & Contact Information
Ordering Code : AS5170-SO_EK_SB
Description : AS5170 Eval Kit Socket Board
Buy our products or get free samples online at:
www.ams.com/ICdirect
Technical Support is available at:
www.ams.com/Technical-Support
Provide feedback about this document at :
www.ams.com/Document-Feedback
For further information and requests, e-mail us at :
ams_sales@ams.com
For sales offices, distributors and representatives, please visit:
www.ams.com/contact
Copyrights & Disclaimer
Copyright ams AG, Tobelbader Strasse 30, 8141 Unterpremstaetten, Austria- Europe. Trademarks Registered. All rights reserved. The material herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright owner.
Demo Kits, Evaluation Kits and Reference Designs are provided to recipient on an “as is” basis for demonstration and evaluation purposes only and are not considered to be finished end-products intended and fit for general consumer use, commercial applications and applications with special requirements such as but not limited to medical equipment or automotive applications. Demo Kits, Evaluation Kits and Reference Designs have not been tested for compliance with electromagnetic compatibility (EMC) standards and directives, unless otherwise specified. Demo Kits, Evaluation Kits and Reference Designs shall be used by qualified personnel only.
ams AG reserves the right to change functionality and price of Demo Kits, Evaluation Kits and Reference Designs at any time and without notice.
Any express or implied warranties, including, but not limited to the implied warranties of merchantability and fitness for a particular purpose are disclaimed. Any claims and demands and any direct, indirect, incidental, special, exemplary or consequential damages arising from the inadequacy of the provided Demo Kits, Evaluation Kits and Reference Designs or incurred losses of any kind (e.g. loss of use, data or profits or business interruption however caused) as a consequence of their use are excluded.
ams AG shall not be liable to recipient or any third party for any damages, including but not limited to personal injury, property damage, loss of profits, loss of use, interruption of business or indirect, special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing, performance or use of the technical data herein. No obligation or liability to recipient or any third party shall arise or flow out of ams AG rendering of technical or other services.
Customer Support
Headquarters ams AG Tobelbaderstrasse 30 8141 Unterpremstaetten
Austria, Europe
Tel: +43 (0) 3136 500 0
Website : www.ams.com